Datasheet

UG-408 Evaluation Board User Guide
Rev. A | Page 12 of 20
After installation from the CD is complete, connect the
AD7366/AD7367 evaluation board to the E VA L -SDP-CB1Z
as described in the Evaluation Board Hardware section.
When you first plug in the EVA L-SDP-CB1Z board via the USB
cable provided, allow the new Found Hardware Wizard to run.
Once the drivers are installed, you may check that the board has
connected correctly by looking at the Device Manager of the
PC. The Device Manager can be found by right clicking on My
Computer>Manage>Device Manager from the list of System
Tools as shown in Figure 13. The E VA L -SDP-CB1Z board
should appear under ADI Development Tools. This completes
the installation.
06704-013
Figure 13. Device Manager
LAUNCHING THE SOFTWARE
Once the AD7366SDZ/EVAL-AD7367SDZ and EVA L-SDP-
CB1Z are correctly connected to your PC, the AD7366/AD7367
software can be launched.
To launch the software, complete the following steps:
1. From the Start menu, select Programs>Analog
Devices>AD7366/AD7367. The main window of the
software then displays.
2. If the AD7366/AD7367 evaluation system is not connected
to the USB port via the E VA L-SDP-CB1Z when the software
is launched, a connectivity error displays (see Figure 14).
Connect the evaluation board to the USB port of the
PC, wait a few seconds, click Rescan, and follow the
instructions.
06704-014
Figure 14. Connectivity Error Alert
SOFTWARE OPERATION
When the software is launched, the panel opens and the soft-
ware looks for hardware connected to the PC. The software
detects the generic attached to the PC and returns this in a
user dialog box.
The user software panel then launchs as shown in Figure 15.