Datasheet

EVAL-AD7262/AD7264
Rev. 0 | Page 10 of 20
07606-003
Figure 3. AD7262 Main Window
SOFTWARE OPERATION
With the hardware set up, use the software to control the EVAL-
CED1Z and the EVAL-AD7262/AD7264. To launch the software
from the Analog Devices menu, use the following steps:
1. Click the AD7274/AD7262 submenu.
2. Click the AD7274/AD7262 icon. Figure 3 displays the
main window that is opened.
3. If an error message appears, click OK and restart the
application after checking the connection between the
adapter board and the USB port on the PC. Also check
that the USB device is identified by the device manager
as detailed in the Installing the Software section.
The software that controls the EVAL-
CED1Z and, therefore,
the AD7262/AD7264 evaluation board, has two main windows.
Figure 3 shows the window that appears when the software is
run. The main function of this window is to allow you to read
a predetermined number of samples from the evaluation board
and display them in both the time and frequency domain. The
top portion of the screen contains the menu bar and the screen
can be divided into three main sections: Part Information,
Data Capture, and Linearity. The Data Capture tab consists
of four subtabs: Waveform, Histogram, FFT, and Summary.
The Linearity tab enables you to generate a linearity plot for
the device.