Datasheet

UG-532 Evaluation Board User Guide
Rev. 0 | Page 10 of 12
ORDERING INFORMATION
COMPONENTS LIST
Table 4.
Qty Reference Designator Description Supplier/Part Number
8 C1, C3, C5, C7, C8, C9, C16, C20 10 µF, 10 V capacitor, Case A FEC 197-130
10 C2, C4, C6, C10 to C12, C15,
C21 to C23
100 nF, 50 V capacitor, 0603 FEC 8820023
8 C13, C17 to C19, C24 to C27 N/A Not inserted
1 C14 1 µF, 10 V capacitor, 0603, FEC 318-8840
3 J1, J2, J3 2-pin terminal block (5 mm pitch) FEC 151789
1 J4 120-way female connector, 0.6mm pitch FEC 1324660 or Digi-Key H1219-ND
1 J5 10-pin (2 × 5) 0.1" pitch SMT header FEC 1022244 (36-pin strip)
1 L1 Ferrite bead Digi-Key 490-1024-1-ND
4 LK1, LK4, LK5, LK6 Jumper block using 3-pin SIP header FEC 1022248 and 150410
1 LK2 6-pin (3 × 2) 0.1" header and shorting block FEC 148-535 and 150-411 (36-pin strip)
1 LK3 8-pin (4 × 2) 0.1" header and shorting block FEC 1022244 and 150-411 (36-pin strip)
1 R1 300 kΩ resistor, 0603 Digi-Key 541-300KHCT-ND
1 R2 1 MΩ resistor, 0603 Digi-Key RMCF1/161MFRCT-ND
1 R3 1.5 Ω resistor, 0603 FEC 9331832
2 R4, R11 0 Ω resistor, 0805 FEC 9333681
11 R5 to R7, R10, R12 to R16, R19, R22 N/A Not inserted
2 R8 to R9 10 kΩ resistor, 0603 FEC 933-0399
4 R17 to R18, R20 to R21 10 kΩ resistor, 0603 FEC 933-0402
2 R23, R24 2.2 kΩ resistor, 0603 FEC 157 7611
9 TP1 to TP9 Red test point FEC 8731144 (pack)
1 U1 Adjustable LDO regulator Analog Devices ADP3331ARTZ
1 U2 32K I
2
C serial EEPROM FEC 1331330
1 U3 +5 V voltage regulator Analog Devices ADP3367ARZ
1
U4
Voltage reference
Analog Devices ADR431ARZ
1 U5 Quad, 16-/16-Bit nanoDAC+ with I
2
C
interface
Analog Devices AD5694BRUZ/AD5696BRUZ
1 U6 Voltage reference Analog Devices ADR435ARZ
1 U7 Quad, 16-/16-bit nanoDAC+ with 2 ppm/°C
on-chip reference and I
2
C interface
Analog Devices AD5694RBRUZ/
AD5696RBRUZ
9 EXT_REF, VOUTA1, VOUTA2,
VOUTB1, VOUTB2, VOUTC1,
VOUTC2, VOUTD1, VOUTD2
Straight PCB mount SMB jack–50 Ω FEC 1206013