Datasheet

UG-459 Evaluation Board User Guide
Rev. 0 | Page 10 of 12
ORDERING INFORMATION
COMPONENTS LIST
Table 4.
Qty Reference Designator Description Supplier/Part Number
1 U7 Quad, 16-bit/12-bit nanoDAC+ with SPI interface Analog Devices AD5686/AD5684
1 U5 Quad, 16-bit/12-bit nanoDAC+ with 2 ppm/°C
on-chip reference and SPI interface
Analog Devices AD5686R/AD5684R
1 U1 High accuracy, ultralow quiescent current LDO, SOT-23 Analog Devices ADP3331
1 U3 5 V fixed, adjustable low dropout linear voltage
regulator
Analog Devices ADP3367
1 U6 Ultralow noise XFET 2.5 V voltage reference with
current sink and source capability
Analog Devices ADR431
1 U4 Ultralow noise XFET 5.0 V voltage reference with
current sink and source capability
Analog Devices ADR435
8 VOUTA,VOUTA1, VOUTB, VOUTB2,
VOUTC, VOUTC1, VOUTD, VOUTD1
50 Ω SMB jack FEC 1206013
1 L1 Ferrite bead, 600 Ω at 100 MHz Digi-Key 490-1024-1-ND
1 R1 0603, 300 kΩ resistor Digi-Key 541-300KHCT-ND
1 R2 Resistor, 1 MΩ, 1%, 0.063W, 0603 Digi-Key RMCF1/161MFRCT-ND
1 J4 120-pin female connector FEC 1324660 or Digi-Key H1219-ND
1 U2 32K, I
2
C serial EEPROM (24LC32) FEC 1331330
1 C14 Capacitor, 0603, 1 µF, 10 V FEC 318-8840
1 R3 Resistor, 1.5 Ω, 5%, 0.063W, 0603 FEC 9331832
2 R8, R9 10 kΩ SMD resistor FEC 9330399
2 R17, R18 100 kΩ SMD resistor FEC 9330402
2 R4, R11 0 Ω resistor, 0805 FEC 9333681
3 J5, LK3, LK6 Terminal block, 8-pin (4 × 2) 0.1" header FEC 1022244
3
J1, J2, J3
2-pin terminal block
FEC 151789
4
LK1, LK2, LK4, LK5
Jumper block using 3-pin SIP header
FEC 1022248 and FEC 150410
8 C1, C3, C5, C7, C8, C9, C16, C20 Case A, 10 µF capacitor FEC 197-130
9 TP1, TP2, TP3, TP4, TP5, TP6, TP7, TP8, TP9 Red test point FEC 8731144 (pack)
10 C2, C4, C6, C10, C11, C12, C15, C21, C22, C23 Capacitor, 0.1 µF, 50 V, 0603 FEC 8820023
17 C13, C17, C18, C19, C24, C25, C26, C27,
R5, R6, R7, R10, R12, R13, R14, R15, R16
Do not populate (DNP) Not Inserted