Datasheet

Evaluation Board User Guide UG-391
Rev. 0 | Page 3 of 16
EVALUATION BOARD HARDWARE
POWER SUPPLIES
The EVAL-MB-LV-SDZ supports using single power supplies.
The evaluation board can be powered either from the SDP port
or externally by the J1 and J2 connectors, as described in Table 1.
All supplies are decoupled to ground using 10 μF tantalum and
0.1 μF ceramic capacitors.
Table 1. Maximum and Minimum Voltages of the Connectors
Connector
No. Label Voltage
J1-1 EXT VDD Analog positive power supply, V
DD
,
from 2.7 V to 5.5 V
J1-2 GND Analog ground
J2-1 VLOGIC Digital supply, from 2.7 V to V
DD
J2-2 DGND Digital ground
Link Options
Several link and switch options are incorporated in the EVAL-
MB-LV-SDZ board and should be set up before using the board.
Table 2 describes the positions of the links to control the
evaluation board by a PC, via the SDP board. The functions of
these link options are described in detail in Table 3 through
Table 6.
Table 2. Link Options Setup for SDP Control (Default)
Link No. Option
A11 3.3 V
A12 AGND
A5 3.3 V
Table 3. Link Functions
Link No. Power Supply Options
A11 V
DD
This link selects one of the following as the positive power supply:
5 V (from SDP).
3.3 V (from SDP).
EXT VDD (external supply from the J1 connector).
A5 V
LOGIC
This link selects one of the following as the digital supply:
3.3 V (from SDP).
VLOGIC (external supply from the J2 connector).
A12 GND AGND.