Datasheet

UG-347 EVAL-AD5232SDZ User Guide
Rev. 0 | Page 6 of 16
EVALUATION BOARD SOFTWARE
INSTALLING THE SOFTWARE
The EVAL-AD5232SDZ evaluation kit includes evaluation
board software provided on a CD. The software is compatible
with Windows® XP, Windows Vista, and Windows 7 (both
32-bit and 64-bit).
Install the software before connecting the SDP-B board to the USB
port of the PC to ensure that the SDP-B board is recognized
when it is connected to the PC.
1.
Start the Windows operating system and insert the CD.
2.
The installation software must open automatically. If it
does not, run the
setup.exe file from the CD.
3.
After installation is completed, power up the evaluation
board as described in the Power Supplies section.
4.
Plug the EVAL-AD5232SDZ into the SDP-B board and the
SDP-B board into the PC using the USB cable provided.
5.
When the software detects the evaluation board, follow the
instructions that appear to finalize the installation.
To uninstall the program, click
Start > Control Panel > Add or
Remove Programs
> AD5232 Eval Board.
RUNNING THE SOFTWARE
To run the evaluation board software, do the following:
1.
Click Start > All Programs > Analog Devices > AD5232
>
AD5232 Eval Board.
2.
If the SDP-B board is not connected to the USB port when
the software is launched, a connectivity error is displayed
(see Figure 8). Connect the evaluation board to the USB
port of the PC, wait a few seconds, click
Rescan, and follow
the instructions.
10365-010
Figure 8. Pop-Up Window Error
The main window of the EVAL-AD5232SDZ software then
opens, as shown in Figure 9.
10365-011
Figure 9. EVAL-AD5232SDZ Software Main Window