Datasheet

Evaluation Board User Guide UG-322
Rev. 0 | Page 5 of 12
EVALUATION BOARD SOFTWARE
INSTALLING THE SOFTWARE
The E VA L -AD5110SDZ evaluation kit includes evaluation
board software provided on a CD. The software is compatible
with Windows® XP, Windows Vista, and Windows 7 (both 32
and 64 bits).
Install the software before connecting the SDP board to the USB
port of the PC to ensure that the SDP board is recognized when
it is connected to the PC.
1. Start the Windows operating system and insert the CD.
2. The installation software opens automatically. If it does
not, run the setup.exe file from the CD.
3. After the installation is completed, power up the evaluation
board as described in the Power Supplies section.
4. Plu g t h e EVA L -AD511xSDZ into the SDP board and the SDP
board into the PC using the USB cable included in the box.
5. When the software detects the evaluation board, follow the
instructions that appear to finalize the installation.
To uninstall the program, click Start > Control Panel > Add or
Remove Programs > AD5110 Eval Board.
RUNNING THE SOFTWARE
To run the evaluation board software, use the following steps:
1. Click Start > All Programs > Analog Devices > AD5110
> AD5110 Eval Board.
2. If the SDP board is not connected to the USB port when
the software is launched, a connectivity error is displayed
(see Figure 4). Connect the evaluation board to the USB
port of the PC, wait a few seconds, click Rescan, and follow
the instructions.
10199-004
Figure 4. Pop-Up Window Error
The main window of the EVA L -AD5110SDZ evaluation
software then opens, as shown in Figure 5.
10199-005
Figure 5. EVAL-AD5110SDZ Evaluation Board Software Main Window