Datasheet

UG-096 Evaluation Board User Guide
Rev. A | Page 4 of 12
EVALUATION BOARD SOFTWARE QUICK START PROCEDURES
The control software and USB drivers for EVAL-ADF4360-
1EBZ1 accompany the EVAL-ADF4360-1EBZ1 on a CD.
To install the software, use the following steps:
1. Open ADF4360_Setup.msi.
2. The install wizard guides you through the installation
process. The software and USB drivers will be installed in
the default directory called C:\Program Files\Analog
Devices\ADF4360.
The software requires Microsoft’s .NET Framework Version 2.0
or later to be installed on your machine. The installer automati-
cally downloads the framework from the Microsoft website if
you do not have this installed. If you do not have an Internet
connection or have a slow connection on the PC, then you can
install the .NET framework directly from the CD. Do this by
double-clicking dotnetfx.exe. Once installed, run the
ADF4360_Setup.msi again.
WINDOWS XP OS
Once you have installed the software, install the USB drivers.
To do so, use the following steps:
1. Plug in a USB cable to the USB connector on the
evaluation board. The Found New Hardware box
appears. See Figure 3.
2. Choose Install from a list or specified location
(Advanced).
08880-003
Figure 3. New Hardware Wizard
3. Browse to C:\Program Files\Analog Devices\ADF4360 or
the location where you installed the ADF4360 software.
4. Click Continue Anyway when asked about Windows Logo
testing.
5. If the install was successful, the message box in Figure 4
appears.
08880-004
Figure 4. Successful Install