Datasheet

UG-165 Evaluation Board User Guide
Rev. A | Page 6 of 24
EVALUATION BOARD SETUP PROCEDURE
SOFTWARE INSTALLATION
Use the following steps to install the SDP drivers and Analog
Devices Int-N PLL software.
1. Install the Analog Devices Int-N PLL software by double-
clicking ADI_Int-N_Setup.msi. Note that the version
number may be added to the file name.
If you are using Windows XP, follow the instructions in
the Windows XP Software Installation Guide section (see
Figure 3 to Figure 7).
If you are using Windows Vista or Windows 7, follow the
instructions in the Windows Vista and Windows 7 Software
Installation Guide section (see Figure 8 to Figure 12).
Note that the software requires Microsoft Windows
Installer and Microsoft .NET Framework 3.5 (or higher).
The installer connects to the Internet and downloads
Microsoft .NET Framework automatically. Alternatively,
before running the ADI_Int-N_Setup.msi, both the
installer and .NET Framework can be installed from the
CD provided in the evaluation board kit.
2. Connect your SDP board to EV-ADF4113HVSD1Z and to
the USB port of the PC using the supplied USB cable. If you
are using Windows XP, follow the steps in the Windows XP
Driver Installation Guide section (see Figure 13 to Figure 16).
If you are using Windows Vista or Windows 7, the drivers
install automatically.
Windows XP Software Installation Guide
1. Click Next.
Figure 3. Windows XP Int-N PLL Software Installation,
Setup Wizard
2. Choose an installation directory and click Next.
Figure 4. Windows XP Int-N PLL Software Installation,
Select Installation Folder
09150-003
09150-004