Datasheet

Evaluation Board User Guide UG-165

Rev. A | Page 3 of 24

QUICK START GUIDE

Follow these steps to quickly evaluate the ADF4113HV device:

1. Install the Analog Devices Int-N PLL software.

2. Connect the SDP-S motherboard to the

EV-ADF4113HVSD1Z board and to the PC.

3. Follow the hardware driver installation procedure that

appears if you are using Windows XP.

4. Connect the power supplies to banana connectors (6 V

to 12 V).

5. Connect 15 V to V

6. Run the Analog Devices Int-N PLL software.

7. Select the SDP board and the ADF4113HV device in the

Select Device and Connection tab in the main window of

the evaluation board software.

8. Click the Main Controls tab. Set the correct values for

Reference Frequency (25 MHz) and RF VCO Output

Frequency (ranging from 1200 MHz to 2100 MHz), and

then click Write All Latches.

9. Connect the spectrum analyzer to J2.

10. Measure the results.