Datasheet

UG-165 Evaluation Board User Guide
Rev. A | Page 10 of 24
EVALUATION BOARD SOFTWARE
The control software for the EV-ADF4113HVSD1Z is provided on
a CD included in the evaluation board kit. To install the software,
see the Software Installation section.
To run the software, click the ADI PLL Int-N file on the desktop or
from the Start menu.
On the Select Device and Connection tab, choose the device
and connection method, and then click Connect.
Confirm that SDP board connected is displayed at the bottom
left of the window (see Figure 17). If this message is not displayed,
the software cannot connect to the evaluation board.
Note that when the board is connected, there is about a 5 sec to
10 sec delay before the status label changes.
From the File menu, the current settings can be saved to and
loaded from a text file.
Figure 17. Int-N PLL Software, Main Window—Select Device and Connection
09150-017