Inc. Computer Hardware User Manual

LIST OF TABLES
Table 1-1: Related DSP Documents ................................................................................ 1-5
Table 1-2: Related VisualDSP++ Documents ................................................................. 1-5
Table 2-1: Minimum PC Configuration........................................................................... 2-2
Table 3-1: EZ-KIT Lite Evaluation Board Memory Map ...............................................3-2
Table 3-2: SDRAM Default Settings............................................................................... 3-3
Table 3-3: Programmable Flag Pin Summary ................................................................. 3-5
Table 3-4: Power Management PF Settings..................................................................... 3-6
Table 4-1: Connector Interfaces....................................................................................... 4-4
Table 4-2: Boot Mode Select Switch (SW1) Settings ..................................................... 4-6
Table 4-3: PLL Setup Switch (SW2) Functions .............................................................. 4-7
Table 4-4: Programmable Flag LEDs.............................................................................. 4-9
Table 4-5: Programmable Flag Switches.......................................................................4-10
Table 4-6: Power Connector .......................................................................................... 4-15
Table 4-7: Current Measurement Resistors ................................................................... 4-15
LIST OF FIGURES
Figure 2-1: EZ-KIT Lite Hardware Setup .......................................................................2-4
Figure 2-2: Add New Hardware Wizard Dialog Box ...................................................... 2-5
Figure 2-3: Search for the driver...................................................................................... 2-6
Figure 2-4: Search the CD-ROM..................................................................................... 2-6
Figure 2-5: The driver is located...................................................................................... 2-7
Figure 2-6: Search for .sys File Dialog Box .................................................................... 2-7
Figure 2-7: Open the .sys File.......................................................................................... 2-8
Figure 2-8: Copying Files ................................................................................................ 2-8
Figure 2-9: Finish the Software Installation .................................................................... 2-9
Figure 2-10: Found New Hardware Wizard .................................................................. 2-10
Figure 2-11: Search for a Suitable Driver...................................................................... 2-11
Figure 2-12: Locate Driver Files.................................................................................... 2-12
Figure 2-13: Driver File Search Results ....................................................................... 2-13
Figure 2-14: Completing Driver Installation Dialog Box.............................................. 2-14
Figure 2-15: New Session Dialog Box .......................................................................... 2-15
Figure 3-1: Flash Memory Map....................................................................................... 3-4
Figure 4-1: System Architecture...................................................................................... 4-2
Figure 4-2: Jumper Locations .......................................................................................... 4-5
Figure 4-3: Audio Input Jumper Settings (JP1) ............................................................... 4-6
Figure 4-4: Default PLL Setup Switch Settings (SW2)................................................... 4-7
Figure 4-5: LED and Push Button Locations................................................................... 4-8
Figure 4-6: Connector Locations ................................................................................... 4-11
Figure 4-7: Mechanical Drawing.....................................................................................4-1
ADSP-21535 EZ-KIT Lite Evaluation System Manual
vi