Datasheet

Configuration Switches
2-8 SHARC Audio EZ-Extender Manual
Audio In2 Left Selection Switch (SW9)
The audio selection switch (SW9) connects the left channel of the In2 line,
connected to the AD1939’s ADC3 circuit, to either the single-ended RCA
connectors or the differential DB25 connector. By default, the switch is
set up to use the RCA connectors. The switch circuit is connected to
AD1939A (codec A). To use the standard, off the shelf DB25 connector
to XLR cables, change the switch to the differential setting; see Table 2-3.
See also “Differential In/Out Connectors (P1–5)” on page 2-18.
Audio In2 Right Selection Switch (SW10)
The audio selection switch (SW10) connects the right channel of the In2
line, connected to the AD1939’s ADC4 circuit, to either the single-ended
RCA connectors or the differential DB25 connector. By default, the
switch is set up to use the RCA connectors for audio in. The switch circuit
is connected to AD1939A (codec A). To use the standard, off the shelf
DB25 connector to XLR cables, change the switch to the differential set-
ting; see Table 2-4. See also “Differential In/Out Connectors (P1–5)” on
page 2-18.
Table 2-3. Audio In2 Left Selection Switch (SW9)
SW9 Position Single-Ended Mode
RCA IN (Default)
Differential Mode
DB25 IN (P1)
SW9.1 ON OFF
SW9.2 OFF ON
SW9.3 ON OFF
SW9.4 OFF ON
SW9.5 ON OFF
SW9.6 OFF ON