Datasheet

Software-Controlled Switches (SoftConfig)
2-4 WVGA/LCD EI3 Extender Board Manual
used to change ENABLE_A to a logic 1 through software that interfaces with
the Microchip. The same procedure for ENABLE_B disconnects
EXAMPLE_SIGNAL_C from EXAMPLE_SIGNAL_D.
Figure 2-3 shows the equivalent circuit to Figure 2-2 but utilizes mechan-
ical switches that are in the same package. The default is shown by black
boxes located closer to the ON label of the switches. In order to disconnect
these switches, physically move the switch to the OFF position.
Figure 2-2. Example of Individual FET Switches