Datasheet

Camera EI3 Extender Board Manual 2-5
Camera EI3 Extender Board Hardware Reference
Expansion Interface III (EI3) Connector (J1)
One board-to-board connector (J1) provides signals from the PPI and
TWI ports of the processor. The connector is located on the top side of
the board.
Sensor Connector (J2)
The sensor connector (J2) is a 13 × 2 IDC connector which connects with
an Aptina headboard directly or through a cable. This connector can be
used for interfacing with Aptina CMOS sensor headboards with an 8-, 10-
and 12-bit interface. The connector is located on the bottom side of the
board
Sensor Connector (J3)
The sensor connector (J3) is a 13 × 1 IDC connector which connects with
an Aptina headboard directly or through a cable. This connector is used
for interfacing with Aptina CMOS sensor headboards with a 12-bit inter-
face. The connector is located on the bo
ttom side of the board
Part Description Manufacturer Part Number
120-pin, 0.6 mm HIROSE FX8-120S-SV(21)
Mating Connector
120-pin, 0.6 mm HIROSE FX8-120P-SV1(91)
Part Description Manufacturer Part Number
.025 SQ POST SOCKET 3M 8526-4500PL
Part Description Manufacturer Part Number
.025 SQ POST SOCKET SAMTEC SSW-113-01-T-S