Datasheet

Camera EI3 Extender Board Manual 2-3
Camera EI3 Extender Board Hardware Reference
Jumpers
This section describes jumper functionality. The jumper on the Camera
EI3 Extender Board is located on the back of the board.
Camera Width Jumper (JP1)
The camera width jumper (JP1) determines whether the interface to the
processors PPI is 8, 10 or 12 bits. The camera width is chosen by placing
the jumper in the appropriate position. By default, 8-bit mode is selected
since that is the interface that is on the M114 headboard.
Camera Mode Shunt
8-bit 1 and 2 (default)
10-bit 3 and 4
12-bit 5 and 6