Datasheet

ADSP-BF609 EZ-KIT Lite Evaluation System Manual 2-25
ADSP-BF609 EZ-KIT Lite Hardware Reference
DCE UART Connector (J2)
The pinout of the J2 connector can be found in “ADSP-BF609 EZ-KIT
Lite Schematic” on page B-1.
Link Port /JTAG Connectors (J3 and P8)
The J3 and P8 connectors provide access to the Link Port and JTAG sig-
nals of the ADSP-BF609 processor. J3 supports link port 0 and the P8
connector is for link port 1.
JTAG Connector (P1)
The JTAG interface of the ADSP-BF609 processor is connected to the
14-pin 0.1” header,
P1. Pin 3 is missing to provide keying. Pin 3 in the
mating connector must have a plug. For more information, see “JTAG
Interface” on page 1-18.
Remove the standalone debug agent when an emulator is used with the
board. Follow the installation instructions provided in “EZ-KIT Lite
Installation” on page 1-6, using
P1 as the JTAG connection point.
Part Description Manufacturer Part Number
IDC header FCI 68737-410HLF
Mating Connector
IDC socket DIGI-KEY S4205-ND
Part Description Manufacturer Part Number
ERF8 10X2, RA female (J3) SAMTEC ERF8-010-01-S-D-RA-L
ERm8 10x2, RA male (P8) SAMTEC ERM8-010-01-S-D-RA-TR
Mating Cable
6" cable ERF8 to ERM8 10X2 SAMTEC ERCD-010-06.00-TBL-SBR-1