Datasheet

Connectors
2-24 ADSP-BF609 EZ-KIT Lite Evaluation System Manual
Reset LED (LED7)
When LED4 is lit (red), it indicates that the master reset of the processor is
active. The reset signal is controlled by the Analog Devices ADM13305
supervisory reset circuit.
SPD LED (LED6)
SPD LED indicates the speed of the Ethernet port. When LED6 is lit
(green), the speed is 100 Mb/s and when not lit, the speed is 10 Mb/s.
Connectors
This section describes connector functionality and provides information
about mating connectors. The connector locations are shown in
Figure 2-9.
Figure 2-9. Connector Locations
Components with a dotted outline are on the back side of the board