Datasheet

ADSP-BF609 EZ-KIT Lite Evaluation System Manual 2-21
ADSP-BF609 EZ-KIT Lite Hardware Reference
The rotary encoder can be disconnected from the processor by setting
SoftConfig, see “Software-Controlled Switches (SoftConfig)” on page 2-3
for more information.
Wake Push Switch (SW10)
One of the wake input signals (PE12/~ETH1_PHYINT/PWM1_CL/RSI0_D5) is
connected to a push button switch (
SW10). This feature is disabled by
default and can be enabled through SoftConfig. Refer to “Software-Con-
trolled Switches (SoftConfig)” on page 2-3 for more details.
Power Jumpers
This section describes functionality of the power jumpers (P10-15).
Figure 2-7 shows the jumper locations.
Figure 2-7. Configuration Jumper Locations