Datasheet

ADSP-21369 EZ-KIT Lite Evaluation System Manual 1-5

Using ADSP-21369 EZ-KIT Lite

3. Plug the provided power supply into

J4 on the EZ-KIT Lite board.

Visually verify that the green power LED (LED9) is on. Also verify

that the red reset LED (LED10) goes on for a moment and then goes

off, and, finally, LED1 through LED8 are sequentially blinking.

4. Connect one end of the USB cable to an available full speed USB

port on your PC and the other end to ZJ1 on the ADSP-21369

EZ-KIT Lite board.

Installation and Session Startup

For correct operation, install the software and hardware in the

order presented in the VisualDSP++ Installation Quick Reference

Card.

1. Verify that the yellow USB monitor LED (ZLED3, located near the

USB connector) is lit. This signifies that the board is communicat-

ing properly with the host PC and is ready to run VisualDSP++.

2. If you are running VisualDSP++ for the first time, navigate to the

VisualDSP++ environment via the Start –> Programs menu. The

main window appears. Note that VisualDSP++ does not connect to

any session. Skip the rest of this step to step 3.

If you have run VisualDSP++ previously, the last opened session

appears on the screen. You can override the default behavior and

force VisualDSP++ to start a new session by pressing and holding

down the Ctrl key while starting VisualDSP++. Do not release the

Ctrl key until the Session Wizard appears on the screen. Go to

step 4.