Datasheet

ADV7188
Rev. A | Page 5 of 112
SPECIFICATIONS
ELECTRICAL CHARACTERISTICS
A
VDD
= 3.15 V to 3.45 V, D
VDD
= 1.65 V to 2.0 V, D
VDDIO
= 3.0 V to 3.6 V, P
VDD
= 1.71 V to 1.89 V, nominal input range 1.6 V.
Operating temperature range, unless otherwise noted.
Table 1.
Parameter Symbol Test Conditions Min Typ Max Unit
STATIC PERFORMANCE
1, , 2 3
Resolution (Each ADC) N 12 Bits
Integral Nonlinearity INL BSL at 54 MHz −1.5/+2.5 ±8 LSB
Differential Nonlinearity DNL BSL at 54 MHz −0.7/+0.7 −0.99/+2.5 LSB
DIGITAL INPUTS
Input High Voltage
4
V
IH
2 V
Input Low Voltage
5
V
IL
0.8 V
Input Current
6, 7
I
IN
−50 +50 μA
−10 +10 μA
Input Capacitance
8
C
IN
10 pF
DIGITAL OUTPUTS
Output High Voltage
9
V
OH
I
SOURCE
= 0.4 mA 2.4 V
Output Low Voltage
9
V
OL
I
SINK
= 3.2 mA 0.4 V
High Impedance Leakage Current I
LEAK
10 μA
Output Capacitance
8
C
OUT
20 pF
POWER REQUIREMENTS
8
Digital Core Power Supply D
VDD
1.65 1.8 2.0 V
Digital Input/Output Power Supply D
VDDIO
3.0 3.3 3.6 V
PLL Power Supply P
VDD
1.71 1.8 1.89 V
Analog Power Supply A
VDD
3.15 3.3 3.45 V
Digital Core Supply Current I
DVDD
105 mA
Digital Input/Output Supply Current I
DVDDIO
4 mA
PLL Supply Current I
PVDD
11 mA
Analog Supply Current I
AVDD
CVBS input
10
99 mA
SCART RGB FB input
11
269 mA
Power-Down Current I
PWRDN
0.65 mA
Power-Up Time t
PWRUP
20 ms
1
All ADC linearity tests performed with the input range at full scale − 12.5% and at zero scale + 12.5%.
2
Maximum INL and DNL specifications obtained with the part configured for component video input.
3
Temperature range T
MIN
to T
MAX
, −40°C to +85°C. The minimum/maximum specifications are guaranteed over this range.
4
To obtain specified V
IH
level on Pin 29, Register 0x13 (write only) must be programmed with Value 0x04. If Register 0x13 is programmed with Value 0x00, then V
IH
on Pin 29 is 1.2 V.
5
To obtain specified V
IL
level on Pin 29, Register 0x13 (write only) must be programmed with Value 0x04. If Register 0x13 is programmed with Value 0x00, then V
IL
on Pin 29 is 0.4 V.
6
Pins 36, 64, 79.
7
Excluding all TEST pins (TEST0 to TEST8)
8
V
OH
and V
OL
levels obtained using default drive strength value (0xD5) in Register 0xF4.
9
Guaranteed by characterization.
10
Only ADC0 is powered on.
11
All four ADCs powered on.