Datasheet

ADV3221/ADV3222
Rev. 0 | Page 3 of 20
SPECIFICATIONS
V
S
= ±5 V, T
A
= 25°C, R
L
= 150 Ω, C
L
= 2 pF, ADV3221 at G = +1, ADV3222 at G = +2, unless otherwise noted.
Table 1.
ADV3221 ADV3222
Parameter Test Conditions/Comments Min Typ Max Min Typ Max Unit
DYNAMIC PERFORMANCE
−3 dB Bandwidth 200 mV p-p 1000 800 MHz
2 V p-p 750 750 MHz
Gain Flatness 0.1 dB, 200 mV p-p 100 100 MHz
0.1 dB, 2 V p-p 100 100 MHz
Propagation Delay 2 V p-p 700 650 ps
Settling Time 1%, 2 V step 5 5 ns
Slew Rate 2 V step, peak 2400 2700 V/μs
NOISE/DISTORTION PERFORMANCE
Differential Gain Error NTSC or PAL 0.01 0.02 %
Differential Phase Error NTSC or PAL 0.01 0.02 Degrees
Crosstalk, All Hostile f = 100 MHz −87 −58 dB
f = 5 MHz −100 −85 dB
Off Isolation, Input to Output f = 100 MHz, one channel −67 −72 dB
Input Second-Order Intercept (ADV3222 Only) f = 70 MHz, R
L
= 100 Ω 54 dBm
Input Third-Order Intercept (ADV3222 Only) f = 70 MHz, R
L
= 100 Ω 17 dBm
Output 1 dB Compression Point (ADV3222 Only) f = 70 MHz, R
L
= 100 Ω 18.5 dBm
Input Voltage Noise 10 MHz to 100 MHz 16 17 nV/√Hz
DC PERFORMANCE
Gain Error No load 1 1 %
R
L
= 150 Ω 0.75 0.75 %
Gain Matching Channel-to-channel, no load 1 1 %
OUTPUT CHARACTERISTICS
Output Impedance DC, enabled 0.02 0.04 Ω
Disabled 1 1 MΩ
Output Disable Capacitance Disabled 2.8 3 pF
Output Leakage Current Disabled 2 2 μA
Output Voltage Range No load ±2.9 ±3 ±2.9 ±3 V
R
L
= 150 Ω ±2.8 ±3 ±2.75 ±3 V
Short-Circuit Current 50 50 mA
INPUT CHARACTERISTICS
Input Offset Voltage Worst case (all configurations) ±5 ±21 ±5 ±21 mV
Input Offset Voltage Drift ±10 ±10 μV/°C
Input Voltage Range ±3 ±1.5 V
Input Capacitance Any switch configuration 1.8 1.8 pF
Input Resistance Output enabled 1 10 1 10 MΩ
Input Bias Current Output enabled 5 12 6 12 μA
SWITCHING CHARACTERISTICS
Enable On Time 15 15 ns
Switching Time, 2 V Step 50% A0 to 1% settling 20 20 ns
Switching Transient (Glitch) IN0 to IN1 switching 28 55 mV p-p