Datasheet

ADV3200/ADV3201
Rev. 0 | Page 4 of 36
Parameter Test Conditions/Comments Min Typ Max Unit
Input Capacitance 3 pF
Input Resistance 1 4 MΩ
Input Bias Current
Sync-tip clamp enabled,
V
IN
= VCLAMP + 0.1 V
0.1 3 12 μA
Sync-tip clamp enabled,
V
IN
= VCLAMP − 0.1 V
−2.9 −1 −0.25 mA
Sync-tip clamp disabled −10 −3 μA
SWITCHING CHARACTERISTICS
Enable On Time 50% update to 1% settling 50 ns
Switching Time, 2 V Step 50% update to 1% settling 40 ns
Switching Transient (Glitch) IN00 to IN31, RTI 300 mV p-p
POWER SUPPLIES
Supply Current
ADV3200 VPOS or VNEG, outputs enabled, no load 250 300 mA
VPOS or VNEG, outputs disabled 120 155 mA
ADV3201 VPOS or VNEG, outputs enabled, no load 260 310 mA
VPOS or VNEG, outputs disabled 130 165 mA
DVCC 2.5 3.5 mA
Supply Voltage Range VPOS − VNEG
5 ± 10% to
6.6 ± 10%
V
PSR VNEG, VPOS, f = 1 MHz
ADV3200 −50 dB
ADV3201 −45 dB
OPERATING TEMPERATURE RANGE
Temperature Range Operating (still air) −40 to +85 °C
θ
JA
Operating (still air) 16 °C/W
OSD ENABLED
V
S
= ±2.5 V (ADV3200), V
S
= ±3.3 V (ADV3201) at T
A
= 25°C, G = +1 (ADV3200), G = +2 (ADV3201), R
L
= 150 Ω, all configurations,
unless otherwise noted.
Table 2.
Parameter Test Conditions/Comments Min Typ Max Unit
OSD DYNAMIC PERFORMANCE
−3 dB Bandwidth
ADV3200 200 mV p-p 170 MHz
2 V p-p 135 MHz
ADV3201 200 mV p-p 150 MHz
2 V p-p 130 MHz
Gain Flatness 0.1 dB, 200 mV p-p 35 MHz
0.1 dB, 2 V p-p 35 MHz
Settling Time 1%, 2 V step 6 ns
Slew Rate 2 V step, peak 400 V/μs
OSD NOISE/DISTORTION PERFORMANCE
Differential Gain Error NTSC or PAL
ADV3200 0.12 %
ADV3201 0.35 %
Differential Phase Error NTSC or PAL
ADV3200 0.06 Degrees
ADV3201 0.04 Degrees
Input Voltage Noise 0.5 MHz to 50 MHz
ADV3200 27 nV/√Hz
ADV3201 25 nV/√Hz