Datasheet

ADV3003
Rev. 0 | Page 3 of 16
SPECIFICATIONS
T
A
= 27°C, AVCC = 3.3 V, VTTI = 3.3 V, VTTO = 3.3 V, AVEE = 0 V, differential input swing = 1000 mV, pattern = PRBS 2
7
− 1,
data rate = 2.25 Gbps, TMDS outputs terminated with external 50 Ω resistors to 3.3 V, unless otherwise noted.
Table 1.
Parameter Conditions/Comments Min Typ Max Unit
DYNAMIC PERFORMANCE
Maximum Data Rate (DR) per Channel NRZ 2.25 Gbps
Bit Error Rate (BER) PRBS 2
23
− 1 10
−9
Added Deterministic Jitter DR ≤ 2.25 Gbps, PRBS 2
7
− 1 25 ps (p-p)
Added Random Jitter 1 ps (rms)
Differential Intrapair Skew At output 1 ps
Differential Interpair Skew
1
At output 50 ps
EQUALIZATION PERFORMANCE
Receiver (Fixed Setting)
2
Boost frequency = 1.125 GHz 12 dB
Transmitter (Pre-Emphasis On)
3
Boost frequency = 1.125 GHz 6 dB
INPUT CHARACTERISTICS
Input Voltage Swing Differential 150 1200 mV
Input Common-Mode Voltage (V
ICM
) AVCC − 800 AVCC mV
OUTPUT CHARACTERISTICS
4
High Voltage Level Single-ended high speed channel AVCC − 200 AVCC + 10 mV
Low Voltage Level Single-ended high speed channel AVCC − 600 AVCC − 400 mV
Rise/Fall Time (20% to 80%) 75 178 ps
TERMINATION
Input Termination Resistance Single-ended 50 Ω
Output Termination Resistance Single-ended 50 Ω
POWER SUPPLY
AVCC Operating range (3.3 V ± 10%) 3 3.3 3.6 V
QUIESCENT CURRENT
AVCC Output disabled 20 40 mA
Output enabled, pre-emphasis off 32 50 mA
Output enabled, pre-emphasis on 66 80 mA
VTTI Input termination on
5
40 54 mA
VTTO Output termination on, pre-emphasis off 40 50 mA
Output termination on, pre-emphasis on 80 100 mA
Output disabled 0 1 mA
POWER DISSIPATION
6
Output disabled 66 148 mW
Output enabled, pre-emphasis off 370 553 mW
Output enabled, pre-emphasis on 686 937 mW
PARALLEL CONTROL INTERFACE TX_EN, PE_EN
Input High Voltage, V
IH
2 V
Input Low Voltage, V
IL
0.8 V
1
Differential interpair skew is measured between the TMDS pairs of the HDMI/DVI link.
2
ADV3003 output meets the transmitter eye diagram mask as defined in the HDMI Standard Version 1.3a and the DVI Standard Version 1.0.
3
Cable output meets the receiver eye diagram mask as defined in the HDMI Standard Version 1.3a and the DVI Standard Version 1.0.
4
PE = 0 dB.
5
Typical value assumes the HDMI/DVI link is active with nominal signal swings. Minimum and maximum limits are measured at the extremes of input termination
resistance and input voltage swing, respectively .
6
The total power dissipation excludes power dissipated in the 50 Ω off-chip loads.