Datasheet

Data Sheet ADP8866
Rev. A | Page 45 of 52
Table 85.
Bit Name Bit No. Description
N/A 7 Reserved.
SCD9_HB [6:0]
Sink current for the even numbered pulses when heartbeat mode for this channel is enabled. Use the following DAC code schedule.
See Table 39 for a complete list of values.
DAC
Code
Current (mA)
(Full Scale = 25 mA)
LEVEL_SET = 000010
Current (mA)
(Full Scale =
12.5 mA)
LEVEL_SET = 001100
Current (mA)
(Full Scale =
8.25 mA)
LEVEL_SET = 010110
Current (mA)
(Full Scale =
6.25 mA)
LEVEL_SET = 100000
Current (mA)
(Full Scale =
5.0 mA)
LEVEL_SET =
101010
0x00 0.0 0.0 0.0 0.0 0.0
0x01 0.0016 0.0008 0.0005 0.0004 0.0003
0x02 0.0062 0.0031 0.0021 0.0016 0.0012
0x03 0.014 0.0070 0.0047 0.0035 0.0028
0x7F 25.0 12.5 8.33 6.25 5.0
Independent Sink 6 Off TimerEven Heartbeat Pulses (OFFTIMER6_HB)Register 0x31
Table 86. OFFTIMER6_HB Bit Map
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Reserved
SC6OFF_HB
Table 87.
Bit Name Bit No. Description
N/A 7 Reserved.
SC6OFF_HB [6:0] SC6 off time for the even numbered pulses when heartbeat mode for this channel is enabled. When the
SC6OFF_HB time is disabled, SC6 goes immediately from the even numbered on time to the odd numbered on
time. When the SC off time is set to any other value, the ISC turns off for the off time (per the following listed
times) and then turns on according to the SCON6_HB setting.
0000 = disabled
1
.
0000001 = 0.0 sec
2
.
0000010 = 0.1 sec.
0000011 = 0.2 sec.
1111110 = 12.5 sec.
1111111 = off
3
.
1
A disabled setting leaves the LED on. This is useful for setting up a blink sequence that runs once and then stays on.
2
Setting SCxOFF_HB to 0 seconds is not recommended if the SCFO_HB fade-out time is also set to 0 seconds.
3
Setting SCxOFF to off causes the LED to be held off indefinitely. This is useful for setting up a blink sequence that runs once and then goes to off.
Independent Sink 7 Off TimerEven Heartbeat Pulses (OFFTIMER7_HB)Register 0x32
Table 88. OFFTIMER7_HB Bit Map
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Reserved SC7OFF_HB