Datasheet

ADP2442 Data Sheet
Rev. 0 | Page 4 of 36
Parameter Symbol Test Conditions/Comments Min Typ Max Unit
POWER GOOD
PGOOD High, FB Rising Threshold
5
89 92 95 %
PGOOD Low, FB Rising Threshold
5
111 115 118 %
PGOOD High, FB Falling Threshold
5
106 109 112 %
PGOOD Low, FB Falling Threshold
5
83
86
89
%
PGOOD
Delay t
PGOOD
50 µs
High Leakage Current I
PGOOD(SRC)
V
PGOOD
= V
CC
1 10 µA
Pull-Down Resistor I
PGOOD(SNK)
FB = 0 V 0.5 0.7 kΩ
SYNC/MODE
SYNC/MODE Input
Logic High 2 V
Logic Low 0.8 V
Pulse Width
100
ns
1
Guaranteed by design.
2
Measured between VIN and SW pins and includes bond wires and pin resistance.
3
Based on bench characterization. Measured with V
IN
= 12 V, V
OUT
= 1.2 V, load = 1 A, f
SW
= 1 MHz, and the output in regulation. Measurement does not include dead time.
4
Based on bench characterization. Measured with V
IN
= 15 V, V
OUT
= 12 V, load = 1 A, f
SW
= 600 kHz, and the output in regulation. Measurement does not include dead time.
5
This threshold is expressed as a percentage of the nominal output voltage.