Datasheet

Evaluation Board User Guide UG-139
Rev. A | Page 5 of 16
USING THE SOFTWARE GUI
HARDWARE CONFIGURATION AND MONITORS
Complete the following steps to load the ADP1650 evaluation
software:
1. Before running the software, ensure that the motherboard
is plugged into the computer USB port (the 3.3 V OK LED
on the motherboard should light up).
2. Ensure that the daughterboard is supplied with a source
that can supply 3 A.
3. Click the Start button at the bottom left on your desktop.
4. Select All Programs, then the Analog Devices folder, and
then ADP1650 Evaluation Software v1.0 to load the
software.
The user registers window shown in Figure 8 is displayed.
6
5
3
4
2
7
1
OUTPUT ENABLE MUST
BE HIGH TO TURN ON FLASH LED
8
ENABLE MUST BE HIGH
TO ACTIVATE I
2
C
09024-008
Figure 8. ADP1650 Evaluation Software GUI: User Registers Window