Datasheet

Data Sheet ADP1053
Rev. A | Page 45 of 84
Command Name
0xFE58 OUT7 rising edge timing (MSBs)
0xFE59 OUT7 falling edge timing (MSBs)
0xFE5A OUT7 rising and falling edge timing (LSBs)
0xFE5B OUT7 settings
0xFE5C OUT8 rising edge timing (MSBs)
0xFE5D OUT8 falling edge timing (MSBs)
0xFE5E OUT8 rising and falling edge timing (LSBs)
0xFE5F OUT8 settings
0xFE60 PWM output pin disable
GO Command Register
0xFE61 GO commands
Balance Control Registers
0xFE62 Balance control on OUT1 and OUT2
0xFE63 Balance control on OUT3 and OUT4
0xFE64 Balance control on OUT5, OUT6, OUT7, and OUT8
Synchronization Setting Registers
0xFE65
OUT1 and OUT2 shutdown in Channel C
synchronization
0xFE66
OUT1 through OUT8 dead time adjustment in
synchronization
SR and Channel C Soft Start Setting Registers
0xFE67 Synchronous rectifier (SR) soft start
0xFE68 Channel C soft start
Light Load PWM Disable Registers
0xFE69 Channel A light load mode PWM output disable
0xFE6A Channel B light load mode PWM output disable
Fast OCP and Channel C Current Sense Setting Registers
0xFE6B CS1_A blanking reference edge
0xFE6C CS1_B blanking reference edge
0xFE6D
OUT3, OUT4, OUT7, and OUT8 cycle-by-cycle OCP
response
0xFE6E CS gain trim
0xFE6F CS OCP settings
0xFE70 CS1_A OCP settings
0xFE71 CS1_B OCP settings
0xFE72 Balance control settings
Temperature Sense and Protection Setting Registers
0xFE75 OTP1 threshold
0xFE76 OTP2 threshold
ACSNS and Feedforward Setting Registers
0xFE77 ACSNS gain trim
0xFE78 ACSNS setting
PSON Registers
0xFE79 Channel A PSON setting
0xFE7A Channel B PSON setting
0xFE7B
Additional flag reenable delay and Channel C
PSON setting
Command Name
RTD Trim Registers
0xFE73 RTD1 gain trim
0xFE74 RTD2 gain trim
0xFE7C RTD1 offset trim (MSB)
0xFE7D RTD1 offset trim (LSBs)
0xFE7E RTD2 offset trim (MSB)
0xFE7F RTD2 offset trim (LSBs)
0xFE80 RTD1 current source settings
0xFE81 RTD2 current source settings
Customized Registers
0xFE82 Custom register
0xFE83 REVERSE_A/REVERSE_B flag configuration
0xFE84 REVERSE_A flag settings
0xFE85 REVERSE_B flag settings
0xFE86 VS_A slew rate for output voltage adjustment
0xFE87 VS_B slew rate for output voltage adjustment
0xFE88 Power supply software reset control
0xFE89 CS, CS1, and CS2 ADC update rate
0xFE8A OTW1/OTW2 settings
Flag Registers
0xFEC0 Flag Register 1
0xFEC1 Flag Register 2
0xFEC2 Flag Register 3
0xFEC3 Flag Register 4
0xFEC4 Flag Register 5
0xFEC5 Latched Flag Register 1
0xFEC6 Latched Flag Register 2
0xFEC7 Latched Flag Register 3
0xFEC8 Latched Flag Register 4
0xFEC9 Latched Flag Register 5
0xFECA Channel A first flag ID
0xFECB Channel B first flag ID
Value Registers
0xFED0 CS value
0xFED1 CS1_A value
0xFED2 CS1_B value
0xFED3 CS2_A value
0xFED4 CS2_B value
0xFED5 VS_A value
0xFED6 VS_B value
0xFED7 RTD1 value
0xFED8 RTD2 value
0xFED9 ACSNS value
0xFEDA Channel A duty cycle value
0xFEDB Channel B duty cycle value