Datasheet
UG-320 Evaluation Board User Guide
Rev. A | Page 14 of 48
CONFIGURING FLAG SETTINGS
When a flag is triggered, the ADP1046 state machine waits
for a programmable length of debounce time before taking
any action. The response to each flag can be programmed
individually. Click Setup and then Flag Settings (see Figure 9)
to configure the flags. The Flag Settings window shows all the
fault flags (if any) and the readings on one page (see Figure 12).
The Get First Flag button (see Figure 11), which can be
accessed by clicking the Monitor tab, determines the first flag
that was set in case of a fault event.
10180-011
Figure 12. Flag Settings Window—Fault Configurations