Datasheet

UG-320 Evaluation Board User Guide

Rev. A | Page 10 of 48

5. The software should report that the ADP1046 has been

located on the board. Click Finish to proceed to the main

software interface setup window (see Figure 9). The serial

number shown next to the checkbox (see Figure 7) indi-

cates the USB dongle serial number. The windows also

displays the device I

C address.

10180-006

Figure 7. ADP1046 Address of 0x50 in the GUI

6. If the software does not detect the part, it enters simulation

mode. Ensure that the connecter is connected to J10 (on

the main board) or J7 (on the daughter card). Click the

Scan Now icon (see Figure 8).

7. Click the Store Board Settings to EEPROM icon (see

Figure 8), and select the ADP1046_I2SF_B_xxx.46b file.

This file contains all the board information, including the

values of the shunt and voltage dividers. Note that all board

setting files have an extension of .46b.

10180-007

SCAN

NOW

DASHBOARD

FOR

MONITOR

AND CONTROL

AND LOAD/SAVE

FILES

SAVE

REGISTERS

TO EEPROM

SPY

WINDOW

LOCK/

UNLOCK

TRIM

REGISTERS

STORE

BOARD

SETTINGS

TO EEPROM

Figure 8. Scan for ADP1046 Now Icon

10180-010

Figure 9. Main Setup Window of the ADP1046 GUI