Datasheet
ADM709
REV. 0
–3–
RESET at Voltages < 1 V
The ADM709 RESET output is guaranteed to operate with
supply voltages as low as 1 V. If it is desired that the
RESET
output remains low below 1 V, then a pull-down resistor should
be connected between the
RESET output and GND. A resistor
of 100 kΩ is suitable. This is illustrated in Figure 5.
R1
RESET
ADM709
GND
Figure 5.
RESET
Valid @ V
CC
< 1 V
Glitch Immunity
The ADM709 is immune to short transients which may occur
on the V
CC
line. This is important so that spurious resets are not
generated as a result of minor glitches on the power supply.
Additional glitch immunity may be obtained by connecting a
capacitor (0.1 µF or greater) as close as possible to the V
CC
pin
on the device.
Microprocessors with Bidirectional I-O
Some microprocessors or microcontrollers such as the
MC68HC11 have bidirectional reset lines. In order to avoid
signal contention, a resistor of 4.7 kΩ should be connected
between the ADM709
RESET output and the microcontroller
RESET line. This arrangement is shown in Figure 6.
RESET
ADM709
GND GND
µP
BUFFERED
RESET
+5V
RESET
V
CC
Figure 6. Interfacing to Microprocessors with
Bidirectional
RESET
V
CC
RESET
ADM709
V
TH
RESET
GENERATOR
GND
Figure 1. Functional Block Diagram
RESET
ADM709
GND GND
µP
RESET
V
CC
V
CC
Figure 2. Typical Operating Circuit
CIRCUIT INFORMATION
RESET Output
RESET is an active low output which provides a reset signal to
the microprocessor whenever the V
CC
supply voltage is below
the reset threshold. An internal timer holds
RESET low for
140 ms after the voltage on V
CC
rises above the threshold. This
is intended as a power-on reset signal for the processor. It allows
time for the power supply and microprocessor to stabilize after
power up. Similarly a power supply brownout will initiate a pro-
cessor reset. On power-down, the
RESET output remains low
with V
CC
as low as 1 V. This ensures that the microprocessor is
held in a stable shutdown condition as the power supply drops.
VRT VRT
t
RS
V
CC
RESET
Figure 3. Power Off/On
RESET
Timing
V
CC
RESET
400ms/DIV
Figure 4.
RESET
Output vs. V
CC