5 kV ESD Protected, 2.7 V to 3.6 V Serial Port Transceivers with Green Idle ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E1 Data Sheet FEATURES FUNCTIONAL BLOCK DIAGRAMS Green Idle power-saving mode Single 2.7 V to 3.6 V power supply Operates with 3 V logic 0.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet TABLE OF CONTENTS Features .............................................................................................. 1 Typical Performance Characteristics ........................................... 10 Applications ....................................................................................... 1 Circuit Description......................................................................... 13 Functional Block Diagrams ..................
Data Sheet ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E GENERAL DESCRIPTION The ADM3307E/ADM3310E/ADM3311E/ADM3312E/ ADM3315E line of driver/receiver products is designed to fully meet the EIA-232 standard while operating with a single 2.7 V to 3.6 V power supply. The devices feature an on-board charge pump dc-to-dc converter, eliminating the need for dual power supplies.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet SPECIFICATIONS VCC = 2.7 V to 3.6 V, C1 to C5 = 0.1 µF. All specifications TMIN to TMAX, unless otherwise noted. Table 1 Parameter Operating Voltage Range VCC Power Supply Current ADM3307E Min 2.
Data Sheet Parameter Maximum Data Rate ADM3307E ADM3310E, ADM3311E, ADM3312E, ADM3315E Receiver Propagation Delay, TPHL, TPLH Receiver Output Enable Time, tER Receiver Output Disable Time, tDR Transmitter Propagation Delay, TPHL, TPLH Transition Region Slew Rate ESD PROTECTION (I/O PINS) 1 2 ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Min Typ 250 460 250 720 920 460 3 0.3 0.17 100 300 500 18 ±15 ±15 ±8 Max 1 Measured at +3 V to −3 V or −3 V to +3 V. Includes CMOS I/O, SD, and EN for ADM3307E.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet ABSOLUTE MAXIMUM RATINGS TA = 25°C, unless otherwise noted.
Data Sheet ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E PRODUCT SELECTION GUIDE Table 3. Product Selection Guide Rx 3 No. Rx Active in SD 1 Speed 1 Mbps 3 5 2 460 kbps 3 3 3 5 3 3 1 1 1 460 kbps 460 kbps 460 kbps Generic ADM3307E Supply Voltage 2.7 V to 3.6 V Tx 5 ADM3310E 2.7 V to 3.6 V ADM3311E ADM3312E ADM3315E 2.7 V to 3.6 V 2.7 V to 3.6 V 2.7 V to 3.6 V 1 ICC Max 1.5 mA ICC Shutdown Max1 1 µA RS-232 0.85 mA 1 µA RS-232 RS-232 RS-232 1 mA 1 mA 0.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet V– ADM3307E TOP VIEW (Not to Scale) 23 GND T1IN 7 22 T1OUT 21 T2OUT 20 T3OUT T4IN 10 19 T4OUT T5IN 11 18 T5OUT R1OUT 12 17 R1IN R2OUT 13 16 R2IN R3OUT 14 15 R3IN 32 31 30 29 28 27 26 25 V+ 1 ADM3310E/ ADM3311E 24 23 22 21 20 19 18 17 C1– SD NC T1OUT T2OUT T3OUT R1IN R2IN VCC 3 26 C3– C2– 4 25 V– C1+ 6 ADM3310E/ ADM3311E T1IN 7 TOP VIEW (Not to Scale) EN 5 02915-006 R3OUT R4OUT R5OUT NC NC R5IN R4IN R3IN 9 10
Data Sheet ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Table 4. Pin Function Descriptions Mnemonic VCC V+ Function Power Supply Input 2.7 V to 3.6 V. Internally Generated Positive Supply, 7.25 V (6.5 V Nominal for ADM3310E, ADM3315E). Capacitor C4 is connected between VCC and V+. Internally Generated Positive Supply, −7.25 V (−6.5 V Nominal for ADM3310E, ADM3315E). Capacitor C5 is connected between GND and V−. Ground Pin. Must be connected to 0 V. External Capacitor 1 is connected between these pins.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet TYPICAL PERFORMANCE CHARACTERISTICS 9 TOUTHIGH 7 Tx O/P (V) 5 SD V+ 3 1 –1 –3 –5 02915-010 –7 0 Figure 10. Charge Pump V+ Exiting Shutdown 200 400 600 LOAD CAPACITANCE (pF) 800 1000 02915-013 TOUTLOW Figure 13. Transmitter Output vs. Load Capacitance (VCC = 3.3 V, Data Rate = 460 kbps) 40 35 SLEW RATE (V/µs) 30 SD 25 20 15 10 02915-011 0 0 500 1000 1500 LOAD CAPACITANCE (pF) 2000 2500 02915-014 5 V– Figure 14.
Data Sheet ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E 25 ICC (mA) 20 15 SD 10 5 0 200 400 600 800 LOAD CAPACITANCE (pF) 1000 1200 02915-019 0 02915-016 TX O/P LOW Figure 16. Supply Current vs. Load Capacitance (RL = Infinite) (VCC = 3.3 V, Data Rate = 460 kbps) Figure 19.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet 25 600 500 20 ICC (mA) ICC (µA) 400 300 15 10 200 2.8 3.0 3.2 VCC (V) 3.4 3.6 02915-022 0 2.6 Figure 22. ICC vs. VCC (Unloaded) 2.8 3.0 3.2 VCC (V) 3.4 Figure 23. ICC vs. VCC (RL = 3 kΩ) Rev. J | Page 12 of 20 Downloaded from Arrow.com. 0 2.6 3.
Data Sheet ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E CIRCUIT DESCRIPTION The internal circuitry consists mainly of four sections. These include the following: • A charge pump voltage converter • 3.3 V logic to EIA-232 transmitters • EIA-232 to 3.3 V logic receivers • Transient protection circuit on all I/O lines During the oscillator high phase, S10 and S11 are open, while S8 and S9 are closed. C3 is charged to 3VCC from the output of the voltage tripler over several cycles.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E A block diagram of the Green Idle circuit is shown in Figure 26. Both V+ and V− are monitored and compared to a reference voltage derived from an on-chip band gap device. If either V+ or V− fall below 7 V1, the oscillator starts up until the voltage rises above 7.25 V2.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E 3V Transmitter (Driver) Section EN INPUT The drivers convert 3.3 V logic input levels into EIA-232 output levels. With VCC = 3.0 V and driving an EIA-232 load, the output voltage swing is typically ±6.4 V (or ±5.5 V for ADM3310E and ADM3315E). Unused inputs may be left unconnected, because an internal 400 kV pull-up resistor pulls them high forcing the outputs into a low state.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E The transmitter outputs and receiver inputs have a similar protection structure. The receiver inputs can also dissipate some of the energy through the internal 5 kΩ (or 22 kΩ for the ADM3310E) resistor to GND as well as through the protection diodes. RECEIVER INPUT Rx D1 RIN 02915-030 D2 Figure 30. Receiver Input Protection Scheme TRANSMITTER OUTPUT Tx D1 02915-031 D2 Figure 31.
Data Sheet R1 R2 The ADM3307E/ADM3310E/ADM3311E/ADM3312E/ ADM3315E devices are tested using both of the previously mentioned test methods. All pins are tested with respect to all other pins as per the Human Body Model, ESD Assoc. Std. 55.1 specification. In addition, all I/O pins are tested as per the IEC 1000-4-2 test specification. The products were tested under the following conditions: DEVICE UNDER TEST C1 ESD TEST METHOD R2 C1 HUMAN BODY MODEL ESD ASSOC. STD 55.1 1.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet OUTLINE DIMENSIONS 5.10 5.00 SQ 4.90 PIN 1 INDICATOR 0.30 0.25 0.18 32 25 0.50 BSC 8 17 16 0.80 0.75 0.70 9 BOTTOM VIEW FOR PROPER CONNECTION OF THE EXPOSED PAD, REFER TO THE PIN CONFIGURATION AND FUNCTION DESCRIPTIONS SECTION OF THIS DATA SHEET. 0.05 MAX 0.02 NOM COPLANARITY 0.08 0.20 REF SEATING PLANE 0.25 MIN 112408-A TOP VIEW 3.25 3.10 SQ 2.95 EXPOSED PAD 0.50 0.40 0.
Data Sheet ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E 7.90 7.80 7.70 24 13 4.50 4.40 4.30 6.40 BSC 1 12 PIN 1 0.65 BSC 0.15 0.05 0.30 0.19 1.20 MAX SEATING PLANE 0.20 0.09 0.75 0.60 0.45 8° 0° 0.10 COPLANARITY COMPLIANT TO JEDEC STANDARDS MO-153-AD Figure 39. 24-Lead Thin Shrink Small Outline Package [TSSOP] (RU-24) Dimensions shown in millimeters 9.80 9.70 9.60 28 15 4.50 4.40 4.30 6.40 BSC 1 14 PIN 1 0.65 BSC 0.15 0.05 COPLANARITY 0.10 0.30 0.19 1.20 MAX SEATING PLANE 0.20 0.
ADM3307E/ADM3310E/ADM3311E/ADM3312E/ADM3315E Data Sheet ORDERING GUIDE Model1, 2 ADM3307EARU-REEL7 ADM3307EARUZ ADM3307EARUZ-REEL ADM3307EARUZ-REEL7 ADM3307EACPZ ADM3307EACPZ-REEL ADM3307EACPZ-REEL7 ADM3307EWARUZ-RL7 ADM3310EARU ADM3310EARUZ ADM3310EARUZ-REEL ADM3310EARUZ-REEL7 ADM3310EACPZ ADM3310EACPZ-REEL7 ADM3311EARS ADM3311EARSZ ADM3311EARSZ-REEL ADM3311EARSZ-REEL7 ADM3311EARUZ ADM3311EARUZ-REEL ADM3311EARUZ-REEL7 ADM3311EACPZ ADM3311EACPZ-REEL7 ADM3312EARU ADM3312EARU-REEL7 ADM3312EARUZ ADM3312EARUZ