Datasheet

ADM2483
Rev. B | Page 6 of 20
PACKAGE CHARACTERISTICS
Table 4.
Parameter Symbol Min Typ Max Unit Test Conditions
Resistance (Input-Output)
1
R
I-O
10
12
Ω
Capacitance (Input-Output)
1
C
I-O
3 pF f = 1 MHz
Input Capacitance
2
C
I
4 pF
Input IC Junction-to-Case Thermal Resistance θ
JCI
33 °C/W
Thermocouple located at center of package
underside
Output IC Junction-to-Case Thermal Resistance θ
JCO
28 °C/W
Thermocouple located at center of package
underside
1
Device considered a 2-terminal device: Pins 1, 2, 3, 4, 5, 6, 7, and 8 shorted together, and Pins 9, 10, 11, 12, 13, 14, 15, and 16 shorted together.
2
Input capacitance is from any input data pin to ground.
REGULATORY INFORMATION
The ADM2483 has been approved by the following organizations:
Table 5.
UL
1
CSA VDE
2
Recognized under 1577 component
recognition program
Approved under CSA Component
Acceptance Notice #5A
Certified according to DIN EN 60747-5-2
(VDE 0884 Part 2): 2003-01
Complies with DIN EN 60747-5-2
(VDE 0884 Part 2): 2003-01,
DIN EN 60950 (VDE 0805): 2001-12;
EN 60950:2000
File E214100 File 205078 File 2471900-4880-0001
1
In accordance with UL1577, each ADM2483 is proof tested by applying an insulation test voltage ≥3000 V rms for 1 sec (current leakage detection limit = 5 µA).
2
In accordance with VDE 0884, each ADM2483 is proof tested by applying an insulation test voltage ≥1050 V
PEAK
for 1 sec (partial discharge detection limit = 5 pC).
INSULATION AND SAFETY-RELATED SPECIFICATIONS
Table 6.
Parameter Symbol Value Unit Conditions
Rated Dielectric Insulation Voltage 2500 V rms 1-minute duration
Minimum External Air Gap (Clearance) L(I01) 7.45 min mm
Measured from input terminals to output
terminals, shortest distance through air
Minimum External Tracking (Creepage) L(I02) 8.1 min mm
Measured from input terminals to output
terminals, shortest distance along body
Minimum Internal Gap (Internal Clearance) 0.017 min mm Insulation distance through insulation
Tracking Resistance (Comparative Tracking Index) CTI >175 V DIN IEC 112/VDE 0303 Part 1
Isolation Group IIIa Material Group (Table 1 in DIN VDE 0110,1/89)