Datasheet

ADM12914 Data Sheet
Rev. D | Page 6 of 16
Pin No.
ADM12914-1 ADM12914-2 Mnemonic Description
15 15 TIMER
Adjustable Reset Delay Timer. Connect an external capacitor to the TIMER pin to program
the reset timeout delay. Refer to Figure 15 in the Typical Performance Characteristics
section. Connect this pin to V
CC
to bypass the timer.
16 16 V
CC
Supply Voltage. V
CC
operates as a direct supply for voltages up to 6 V. For voltages greater
than 6 V, it operates as a shunt regulator. A dropper resistor must be used in this
configuration to limit the current to less than 10 mA. When used without the resistor, the
voltage at this pin must not exceed 6 V. A 0.1 μF bypass capacitor or greater should be
used.
1
N/A means not applicable.