Datasheet
ADG836
Rev. A | Page 7 of 16
PIN CONFIGURATIONS
IN1
1
S1A
2
GND
3
S2A
4
IN2
5
D1
10
S1B
9
V
DD
8
S2B
7
D2
6
ADG836
TOP VIEW
(Not to Scale)
04308-002
Figure 2. 10-Lead MSOP (RM-10)
PIN 1
INDICATOR
NC = NO CONNECT
1S1A
2GND
3S2A
9 S1B
8V
DD
7 S2B
4
N
C
5
I
N
2
6
D
2
1
2
N
C
1
1
N
1
1
0
D
1
TOP VIEW
(Not to Scale)
ADG836
04308-003
Figure 3. 12-Lead LFCSP (CP-12)
Table 6. Terminology
V
DD
Most positive power supply potential.
I
DD
Positive supply current.
GND Ground (0 V) reference.
S Source terminal. May be an input or output.
D Drain terminal. May be an input or output.
IN Logic control input.
V
D
(V
S
) Analog voltage on terminals D, S.
R
ON
Ohmic resistance between D and S.
R
FLAT (ON)
Flatness is defined as the difference between the maximum and minimum value of on resistance as measured over the
specified analog signal range.
∆R
ON
On resistance match between any two channels.
I
S
(OFF) Source leakage current with the switch off.
I
D
(OFF) Drain leakage current with the switch off.
I
D
, I
S
(ON) Channel leakage current with the switch on.
V
INL
Maximum input voltage for Logic 0.
V
INH
Minimum input voltage for Logic 1.
I
INL
(I
INH
) Input current of the digital input.
C
S
(OFF) Off switch source capacitance. Measured with reference to ground.
C
D
(OFF) Off switch drain capacitance. Measured with reference to ground.
C
D
, C
S
(ON) On switch capacitance. Measured with reference to ground.
C
IN
Digital input capacitance.
t
ON
Delay time between the 50% and the 90% points of the digital input and switch on condition.
t
OFF
Delay time between the 50% and the 90% points of the digital input and switch off condition.
t
BBM
On or off time measured between the 80% points of both switches when switching from one to another.
Charge Injection A measure of the glitch impulse transferred from the digital input to the analog output during on-off switching.
Off Isolation A measure of unwanted signal coupling through an off switch.
Crosstalk
A measure of unwanted signal, which is coupled through from one channel to another, as a result of parasitic
capacitance.
−3 dB Bandwidth The frequency at which the output is attenuated by 3 dB.
On Response The frequency response of the on switch.
Insertion Loss The loss due to the on resistance of the switch.
THD + N The ratio of the harmonics amplitude plus noise of a signal to the fundamental.