Datasheet

ManualsBrandsANALOG DEVICES ManualsInterface ICsInterface IC - analogue switches MSOP 8

CMOS 1.8 V to 5.5 V, 2.5 Ω

2:1 Mux/SPDT Switch in SOT-23

ADG719

Rev. D

Information furnished by Analog Devices is believed to be accurate and reliable. However, no

responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other

rights of third parties that may result from its use. Specifications subject to change without notice. No

license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

Trademarks and registered trademarks are the property of their respective owners.

One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.

Tel: 781.329.4700 www.analog.com

FEATURES

1.8 V to 5.5 V single supply

4 Ω (max) on resistance

0.75 Ω (typ) on resistance flatness

−3 dB bandwidth > 200 MHz

Rail-to-rail operation

6-Lead SOT-23 package and 8-Lead MSOP package

Fast switching times:

= 12 ns

OFF

= 6 ns

Typical power consumption: (< 0.01 μW)

TTL/CMOS compatible

APPLICATIONS

Battery-powered systems

Communication systems

Sample-and-hold systems

Audio signal routing

Video switching

Mechanical reed relay replacement

FUNCTIONAL BLOCK DIAGRAM

ADG719

NOTES

1. SWITCHES SHOWN FOR A LOGIC 1 INPUT.

08708-001

Figure 1.

GENERAL DESCRIPTION

The ADG719 is a monolithic CMOS SPDT switch. This switch

is designed on a submicron process that provides low power

dissipation yet gives high switching speed, low on resistance,

and low leakage currents.

The ADG719 can operate from a single-supply range of 1.8 V

to 5.5 V, making it ideal for use in battery-powered instruments

and with the new generation of DACs and ADCs from Analog

Devices, Inc.

Each switch of the ADG719 conducts equally well in both

directions when on. The ADG719 exhibits break-before-make

switching action.

Because of the advanced submicron process, −3 dB bandwidths

of greater than 200 MHz can be achieved.

The ADG719 is available in a 6-lead SOT-23 package and an

8-lead MSOP package.

PRODUCT HIGHLIGHTS

1. 1.8 V to 5.5 V Single-Supply Operation. The ADG719

offers high performance, including low on resistance and

fast switching times, and is fully specified and guaranteed

with 3 V and 5 V supply rails.

2. Ver y Low R

(4 Ω Max at 5 V and 10 Ω Max at 3 V). At 1.8 V

operation, R

is typically 40 Ω over the temperature range.

3. Automotive Temperature Range: −40°C to +125°C.

4. On Resistance Flatness (R

FLAT(ON)

) (0.75 Ω typ).

5. −3 dB Bandwidth > 200 MHz.

6. Low Power Dissipation. CMOS construction ensures low

power dissipation.

7. Fast t

OFF

8. Tiny, 6-lead SOT-23 and 8-lead MSOP packages.

Summary of content (16 pages)

PAGE 1
CMOS 1.8 V to 5.5 V, 2.5 Ω 2:1 Mux/SPDT Switch in SOT-23 ADG719 FEATURES FUNCTIONAL BLOCK DIAGRAM 1.8 V to 5.5 V single supply 4 Ω (max) on resistance 0.75 Ω (typ) on resistance flatness −3 dB bandwidth > 200 MHz Rail-to-rail operation 6-Lead SOT-23 package and 8-Lead MSOP package Fast switching times: tON = 12 ns tOFF = 6 ns Typical power consumption: (< 0.01 μW) TTL/CMOS compatible ADG719 S2 D S1 NOTES 1. SWITCHES SHOWN FOR A LOGIC 1 INPUT. 08708-001 IN Figure 1.
PAGE 2
ADG719 TABLE OF CONTENTS Features .............................................................................................. 1 Typical Performance Characteristics ..............................................7 Applications ....................................................................................... 1 Test Circuits ........................................................................................9 Functional Block Diagram .............................................................
PAGE 3
ADG719 SPECIFICATIONS VDD = 5 V ± 10%, GND = 0 V. Table 1. Parameter ANALOG SWITCH Analog Signal Range On Resistance (RON) +25°C 2.5 4 On Resistance Match Between Channels (ΔRON) On Resistance Flatness (RFLAT(ON)) LEAKAGE CURRENTS IS (Off ) Source Off Leakage Channel On Leakage ID, IS (On) DIGITAL INPUTS Input High Voltage, VINH Input Low Voltage, VINL Input Current IINL or IINH DYNAMIC CHARACTERISTICS 1 tON −40°C to +85°C −40°C to +125°C Unit 0 V to VDD V 5 7 Ω typ Ω max 0.1 0.4 0.4 1.2 1.
PAGE 4
ADG719 VDD = 3 V ± 10%, GND = 0 V. Table 2. Parameter ANALOG SWITCH Analog Signal Range On Resistance (RON) +25°C −40°C to +85°C 6 7 10 On Resistance Match Between Channels (ΔRON) On Resistance Flatness (RFLAT(ON)) LEAKAGE CURRENTS Source Off Leakage IS (Off ) Channel On Leakage ID, IS (On) DIGITAL INPUTS Input High Voltage, VINH Input Low Voltage, VINL Input Current IINL or IINH DYNAMIC CHARACTERISTICS 1 tON ±0.01 ±0.25 ±0.01 ±0.
PAGE 5
ADG719 ABSOLUTE MAXIMUM RATINGS TA = 25°C, unless otherwise noted. Table 3.
PAGE 6
ADG719 IN 1 6 D 1 S1 2 GND 3 VDD 4 S2 ADG719 5 D TOP VIEW (Not to Scale) GND 3 4 S1 08708-002 VDD 2 ADG719 TOP VIEW (Not to Scale) Description Drain Terminal. Can be used as an input or output. Source Terminal. Can be used as an input or output. Ground (0 V) Reference Pin. Most Positive Power Supply Pin. Not Internally Connected. Digital Switch Control Pin. Not Internally Connected. Source Terminal. Can be used as an input or output. Table 5.
PAGE 7
ADG719 TYPICAL PERFORMANCE CHARACTERISTICS 0.15 6.0 5.5 VDD = 2.7V VDD = 5V VD = 4.5V/1V VS = 1V/4.5V TA = 25°C 5.0 0.10 RON (Ω) 4.0 VDD = 4.5V VDD = 3.0V 3.5 CURRENT (nA) 4.5 3.0 2.5 VDD = 5.0V 2.0 ID, IS (ON) 0.05 1.5 0 1.0 0.5 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 DRAIN OR SOURCE VOLTAGE (V) 08708-004 0 –0.05 0 Figure 4. On Resistance vs. VD (VS), Single Supplies 20 30 40 50 60 TEMPERATURE (°C) 70 80 90 Figure 7. Leakage Currents vs. Temperature 0.15 6.
PAGE 8
ADG719 –30 0 VDD = 5V, 3V VDD = 5V –40 –60 ON RESPONSE (dB) OFF ISOLATION (dB) –50 –70 –80 –90 –100 –2 –4 –110 100k 1M 10M FREQUENCY (Hz) 100M –6 10k 08708-010 –130 10k Figure 10. Off Isolation vs. Frequency 100k 1M 10M FREQUENCY (Hz) 08708-012 –120 100M Figure 12. On Response vs. Frequency –30 12 VDD = 5V, 3V –40 10 –50 8 6 QINJ (pC) –70 –80 –90 VDD = 5V 4 2 –100 0 VDD = 5V –110 –130 10k 100k 1M 10M FREQUENCY (Hz) 100M –4 0 1 2 3 4 VS (V) Figure 13.
PAGE 9
ADG719 TEST CIRCUITS ID (OFF) S A D ID (ON) S A VS VD V1 A VS VD D 08708-014 RON = V1/IDS Figure 16. On Leakage Figure 15. Off Leakage Figure 14. On Resistance 0.1µF VDD VIN 50% 50% VDD D RL 300Ω GND VOUT 90% 90% VOUT CL 35pF tON tOFF 08708-017 S IN VS Figure 17. Switching Times 0.1µF S1 VS1 VDD VIN VDD D S2 VS2 VIN D2 RL2 300Ω IN 50% 0V CL2 35pF VOUT 50% VOUT 50% 0V tD GND Figure 18. Break-Before-Make Time Delay, tD Rev.
PAGE 10
ADG719 VDD 0.1µF NETWORK ANALYZER VDD S 50Ω IN VS 50Ω D VIN RL VOUT GND OFF ISOLATION = 20 LOG VOUT VS 08708-019 50Ω Figure 19. Off Isolation VDD 0.1µF NETWORK ANALYZER VOUT VDD S1 RL 50Ω D S2 50Ω R 50Ω IN VS CHANNEL-TO-CHANNEL VOUT CROSSTALK = 20 LOG VS 08708-020 GND Figure 20. Channel-to-Channel Crosstalk VDD 0.1µF NETWORK ANALYZER VDD S 50Ω IN VS D GND INSERTION LOSS= 20 LOG RL 50Ω VOUT VOUT WITH SWITCH VOUT WITHOUT SWITCH Figure 21. Bandwidth Rev.
PAGE 11
ADG719 TERMINOLOGY tOFF Delay between Applying the Digital Control Input and the Output Switching Off. RON Ohmic Resistance between D and S. ΔRON On Resistance Match between Any Two Channels that is, RON max − RON min. RFLAT(ON) Flatness is defined as the difference between the maximum and minimum value of on resistance, as measured over the specified analog signal range. IS (Off) Source Leakage Current with the Switch Off. ID, IS (On) Channel Leakage Current with the Switch On.
PAGE 12
ADG719 APPLICATIONS INFORMATION The ADG719 belongs to Analog Devices’ new family of CMOS switches. This series of general-purpose switches has improved switching times, lower on resistance, higher bandwidths, low power consumption, and low leakage currents. ADG719 SUPPLY VOLTAGES Functionality of the ADG719 extends from 1.8 V to 5.5 V single supply, which makes it ideal for battery-powered instruments where power efficiency and performance are important design parameters.
PAGE 13
ADG719 OUTLINE DIMENSIONS 3.20 3.00 2.80 8 3.20 3.00 2.80 5.15 4.90 4.65 5 1 4 PIN 1 IDENTIFIER 0.65 BSC 0.95 0.85 0.75 15° MAX 1.10 MAX 0.80 0.55 0.40 0.23 0.09 6° 0° 0.40 0.25 100709-B 0.15 0.05 COPLANARITY 0.10 COMPLIANT TO JEDEC STANDARDS MO-187-AA Figure 24. 8-Lead Mini Small Outline Package [MSOP] (RM-8) Dimensions shown in millimeters 3.00 2.90 2.80 1.70 1.60 1.50 6 5 4 1 2 3 3.00 2.80 2.60 PIN 1 INDICATOR 0.95 BSC 1.90 BSC 1.45 MAX 0.95 MIN 0.15 MAX 0.05 MIN 0.50 MAX 0.
PAGE 14
ADG719 ORDERING GUIDE Model 1 ADG719BRM ADG719BRM-REEL ADG719BRM-REEL7 ADG719BRMZ ADG719BRMZ-REEL ADG719BRMZ-REEL7 ADG719BRT-REEL ADG719BRT-REEL7 ADG719BRT -500RL7 ADG719BRTZ -500RL7 ADG719BRTZ-R2 ADG719BRTZ-REEL ADG719BRTZ-REEL7 1 Temperature Range −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C −40°C to +125°C Package Description 8-Lead MSOP 8-Lead MSOP 8-Lead M
PAGE 15
ADG719 NOTES Rev.