Datasheet

Data Sheet ADE7816
Rev. A| Page 41 of 48
Note that Address 0xE502, Address 0xE503, Address 0xE50A, and Address 0xE50B are listed in Table 30 and Table 31.
Table 19. CHSTATUS Register (Address 0xE600)
Bits Bit Name
Default
Value Description
[15:6]
Reserved
0x000
These bits should be ignored.
5 OICHANNEL2 0x0 The C or F current channel generated the overcurrent event.
4 OICHANNEL1 0x0 The B or E current channel generated the overcurrent event.
3 OICHANNEL0 0x0 The A or D current channel generated the overcurrent event.
[2:0] Reserved 0x000 Reserved. These bits are always 0.
Table 20. CHNOLOAD Register (Address 0xE608)
Bits Bit Name
Default
Value
Description
[15:6]
Reserved
0x0000000
These bits should be ignored.
5 NOLOADF 0x0 0: Channel F is out of the no load condition.
1: Channel F is in the no load condition.
4 NOLOADE 0x0 0: Channel E is out of the no load condition.
1: Channel E is in the no load condition.
3 NOLOADD 0x0 0: Channel D is out of the no load condition.
1: Channel D is in the no load condition.
2 NOLOADC 0x0 0: Channel C is out of the no load condition.
1: Channel C is in the no load condition.
1 NOLOADB 0x0 0: Channel B is out of the no load condition.
1: Channel B is in the no load condition.
0
NOLOADA
0x0
0: Channel A is out of the no load condition.
1: Channel A is in the no load condition.
Table 21. COMPMODE Register (Address 0xE60E)
Bits Bit Name
Default
Value Description
15 Reserved 0x0 This bit should be ignored.
14 CHANNEL_SEL 0x0 0: the A, B, and C current channels are used for the peak, overcurrent, zero crossing, angle, and
waveform measurements.
1: the D, E, and F current channels are used for the peak, overcurrent, zero crossing, angle, and
waveform measurements.
[13:11] Reserved 0x0 These bits should be ignored.
[10:9] ANGLESEL 0x00 00: the time delays between the voltage and currents are measured.
01: reserved.
10: the angles between current channels are measured.
11: no angles are measured.
[8:0] Reserved 0x1FF These bits should be ignored and not modified.
Table 22. Gain Register (Address 0xE60F)
Bits Bit Name
Default
Value
Description
[15:9] Reserved 0x0000000 These bits should be ignored.
[8:6] PGA3[2:0] 0x000 Gain selection for the D, E, and F current channels.
000: gain = 1.
001: gain = 2.
010: gain = 4.
011: gain = 8.
100: gain = 16.
101, 110, 111: reserved.