Datasheet
ADAU1361
Rev. C | Page 16 of 80
Pin No. Mnemonic Type
1
Description
19 RHP A_OUT Right Headphone Output. Biased at AVDD/2.
20 LHP A_OUT Left Headphone Output. Biased at AVDD/2.
21 MONOOUT A_OUT
Mono Output or Virtual Ground for Capless Headphone. Biased at AVDD/2 when set as mono
output.
22 AGND PWR
Analog Ground. The AGND and DGND pins can be tied together on a common ground plane.
AGND should be decoupled locally to AVDD with a 100 nF capacitor.
23 AVDD PWR
1.8 V to 3.3 V Analog Supply for ADC, Output Driver, and Input to Digital Supply Regulator.
This pin should be decoupled locally to AGND with a 100 nF capacitor.
24 DVDDOUT PWR
Digital Core Supply Decoupling Point. The digital supply is generated from an on-board
regulator and does not require an external supply. DVDDOUT should be decoupled to DGND
with a 100 nF capacitor and a 10 F capacitor.
25 DGND PWR
Digital Ground. The AGND and DGND pins can be tied together on a common ground plane.
DGND should be decoupled to DVDDOUT and to IOVDD with 100 nF capacitors and 10 F
capacitors.
26 ADC_SDATA D_OUT ADC Serial Output Data.
27 DAC_SDATA D_IN DAC Serial Input Data.
28 BCLK D_IO Serial Data Port Bit Clock.
29 LRCLK D_IO Serial Data Port Frame Clock.
30 ADDR1/CDATA D_IN I
2
C Address Bit 1 (ADDR1).
SPI Data Input (CDATA).
31 SDA/COUT D_IO
I
2
C Data (SDA). This pin is a bidirectional open-collector input/output. The line connected to
this pin should have a 2 kΩ pull-up resistor.
SPI Data Output (COUT). This pin is used for reading back registers and memory locations. It is
three-state when an SPI read is not active.
32 SCL/CCLK D_IN
I
2
C Clock (SCL). This pin is always an open-collector input when in I
2
C control mode. The line
connected to this pin should have a 2 kΩ pull-up resistor.
SPI Clock (CCLK). This pin can run continuously or be gated off between SPI transactions.
EP Exposed Pad
Exposed Pad. The exposed pad is connected internally to the ADAU1361 grounds. For
increased reliability of the solder joints and maximum thermal capability, it is recommended
that the pad be soldered to the ground plane. See the Exposed Pad PCB Design section for
more information.
1
A_IN = analog input, A_OUT = analog output, D_IN = digital input, D_IO = digital input/output, D_OUT = digital output, PWR = power.