Datasheet

ADAS3022 Data Sheet
Rev. B | Page 8 of 40
ACQUISITION (n)
UNDEFINED
PHASE
POWER
UP
CONVERSION (n – 1)
UNDEFINED
CNV
BUSY
DIN
CS
SDO
NOTES
1. DATA ACCESS CAN OCCUR DURING A CONVERSION (
t
DDC
), AFTER A CONVERSION ( t
DAC
), OR BOTH DURING AND AFTER A CONVERSION.
THE CONVERSION RESULT AND THE CFG REGISTER ARE UPDATED AT THE END OF A CONVERSION (EOC).
2. DATA ACCESS CAN ALSO OCCUR UP TO
t
DDCA
WHILE BUSY IS ACTIVE (SEE THE DIGITAL INTERFACE SECTION FOR DETAILS). ALL OF THE BUSY
TIME CAN BE USED TO ACQUIRE DATA.
3. A TOTAL OF 16 SCK FALLING EDGES IS REQUIRED FOR A CONVERSION RESULT. AN ADDITIONAL 16 EDGES ARE REQUIRED TO
READ BACK THE CFG RESULT ASSOCIATED WITH THE CURRENT CONVERSION.
4. CS CAN BE HELD LOW OR CONNECTED TO CNV. CS WITH FULL INDEPENDENT CONTROL IS SHOWN IN THIS FIGURE.
5. FOR OPTIMAL PERFORMANCE, DATA ACCESS SHOULD NOT OCCUR DURING THE SAMPLING EDGE. A MINIMUM TIME
OF THE APERTURE DELAY (
t
AD
) SHOULD ELAPSE PRIOR TO DATA ACCESS.
DATA
INVALID
SCK
1 1
1
16/32
1616
X 16
NOTE 3
NOTE 1
NOTE 2
NOTE 2
NOTE 1
NOTE 4
NOTE 5
CFG
INVALID
CFG (n + 2)
DATA (n – 1)
INVALID
ACQUISITION (n + 1)
UNDEFINED
CONVERSION (n)
UNDEFINED
DATA (n – 1)
INVALID
CFG (n + 2)
CFG (n + 3)
DATA (n)
INVALID
ACQUISITION
(n + 2)
CONVERSION (n + 1)
UNDEFINED
DATA (n)
INVALID
CFG (n + 3)
CFG (n + 4)
DATA (n + 1)
INVALID
ACQUISITION
(n + 3)
PHASE
CONVERSION
(n + 2)
CNV
BUSY
DIN
CS
SDO
DATA (n + 1)
INVALID
SCK
1
1
CFG (n + 4) CFG (n + 5)
DATA (n + 2)
ACQUISITION
(n + 4)
CONVERSION
(n + 3)
DATA (n + 2)
CFG (n + 5)
CFG (n + 6)
DATA (n + 3)
CONVERSION
(n + 4)
DATA (n + 3)
CFG (n + 6)
EOC
EOC EOC EOC
EOC SOC
SOC
t
DDC
t
CYC
t
QUIET
t
DAC
t
ACQ
t
AD
t
DDCA
10516-028
Figure 4. General Timing Diagram