Datasheet

ADA4430-1
Rev. C | Page 4 of 20
V
S
= 5 V @ T
A
= 25°C, V
IN
= 1 V p-p, R
L
= 150 Ω, unless otherwise noted.
Table 2.
Parameter Test Conditions/Comments Min Typ Max Unit
ELECTRICAL SPECIFICATIONS
Quiescent Supply Current 2.0 2.4 mA
Quiescent Supply Current ADA4430-1W only: T
MIN
to T
MAX
2.0 3.1 mA
Quiescent Supply Current—Disabled 0.2 10 μA
Quiescent Supply Current—Disabled ADA4430-1W only: T
MIN
to T
MAX
0.2 15 μA
Supply Voltage ADA4430-1W only: T
MIN
to T
MAX
2.5 6 V
Input Voltage Range—Low/High
Limited by output range; see the Applications
Information section
0/2.35 V
Input Resistance 10 MΩ
Input Capacitance 1 pF
Input Bias Current 0.5 μA
Output Voltage Range—Low/High 0.10/4.80 V
Output Offset Voltage 100 145 mV
Output Offset Voltage ADA4430-1W only: T
MIN
to T
MAX
100 200 mV
PSRR Input referred, ADA4430-1W only: T
MIN
to T
MAX
50 61 dB
Pass-Band Gain ADA4430-1W only: T
MIN
to T
MAX
5.85 6 dB
Input-to-Output Isolation—Disabled f = 1 MHz 92 dB
FILTER CHARACTERISTICS
−3 dB Bandwidth ADA4430-1W only: T
MIN
to T
MAX
7.2 9.5 MHz
1 dB Flatness ADA4430-1W only: T
MIN
to T
MAX
5.5 7.9 MHz
Out-of-Band Rejection f = 27 MHz, ADA4430-1W only: T
MIN
to T
MAX
40 50 dB
Differential Gain Modulated 10-step ramp, sync tip at 0 V 0.25 %
Differential Phase Modulated 10-step ramp, sync tip at 0 V 0.15 Degrees
Linear Output Current 40 mA
Group Delay Variation f = 100 kHz to 5 MHz 7.1 ns
Signal-to-Noise Ratio 100% white signal, f = 100 kHz to 5 MHz 76 dB
DISABLE
Disable Input Voltage Device disabled <0.8 V
Device enabled >1 V