Datasheet

Quick Start Guide
©
2010
Analog Devices, Inc. All
rights reserved. Trademarks and
registered trademarks are the property of their respective owners.
D00000
Figure 6 AD9779 SPI VI Panel control
- When the Run
button is clicked, the SPI controller will run once. It will both write and read from the
Forever control will setup the
AD9779A
controls change.
-
The DCO frequency field in the DPGDownloader window should now
- Next hit the download
button. This transfers the data f
-
When the vector has finished downloading, hit the play
- The output from J6
should be a clean
AD9779A/78A/76A
rights reserved. Trademarks and
registered trademarks are the property of their respective owners.
D00000
-0-
1/07(A)
Figure 6 AD9779 SPI VI Panel control
button is clicked, the SPI controller will run once. It will both write and read from the
AD9779A
, and
will continue to read from the chip and will update the SPI when any of the
The DCO frequency field in the DPGDownloader window should now
be reading something close to 20
button. This transfers the data f
rom the PC to the DPG memory.
When the vector has finished downloading, hit the play
button. This starts the DPG2 transmitting data to the eval board.
should be a clean
10MHz tone as shown below:
AD9779A/78A/76A
-DPG2-EBZ
button is clicked, the SPI controller will run once. It will both write and read from the
AD9779A. The Run
will continue to read from the chip and will update the SPI when any of the
be reading something close to 20
0MHz.
button. This starts the DPG2 transmitting data to the eval board.