Datasheet

Quick Start Guide AD9741/3/5/6/7-EBZ

registered trademarks are the property of their respective owners.

D00000-0-1/0

GETTING STARTED – SINGLE TONE TEST

It is suggested that the basic set-up is verified before making any modifications to the evaluation board.

Basic Hardware Set-Up

Connect the equipment to the AD9747 evaluation board per the following table:

Equipment Connects to AD9747 Eval Board

Power Supply) P5 (+5V), P6 (GND

Signal Source J1 (CLOCK IN), Set source to 100MHz, 2dBm output

PC USB Cable XP2

Spectrum Analyzer J5 (IOUT1_P) or J9 (IOUT2_P)

DPG2 P1 and P2

DPGDownloader Software

Power up the DPG and connect the USB cable to the PC. Next, run the DPGDownloader Software. A shortcut will be installed to your

Start menu during the installation of the DAC Software Suite. To begin, click on the DPGDownloader shortcut in your Programs menu,

typically at Start > Programs > Analog Devices > DPG > DPGDownloader.

The basic parts of the DPGDownloader window are; Hardware Config Panel, EVB Config, Vector Generation Pull-Down Menu, Vector

Palette, Vector Selection Panel and the Download and Play buttons.

Figure 3 – DPGDownloader Window