Datasheet

AD9734/AD9735/AD9736
Rev. A | Page 9 of 72
ABSOLUTE MAXIMUM RATINGS
Table 4.
Parameter
With
Respect to
Min Max
AVDD33 AVSS −0.3 V +3.6 V
DVDD33 DVSS −0.3 V +3.6 V
DVDD18 DVSS −0.3 V +1.98 V
CVDD18 CVSS −0.3 V +1.98 V
AVSS DVSS −0.3 V +0.3 V
AVSS CVSS −0.3 V +0.3 V
DVSS CVSS −0.3 V +0.3 V
CLK+, CLK− CVSS −0.3 V CVDD18 + 0.18 V
PIN_MODE DVSS −0.3 V DVDD33 + 0.3 V
DATACLK_IN,
DATACLK_OUT
DVSS −0.3 V DVDD33 + 0.3 V
LVDS Data Inputs DVSS −0.3 V DVDD33 + 0.3 V
IOUTA, IOUTB AVSS −1.0 V AVDD33 + 0.3 V
I120, VREF, IPTAT AVSS −0.3 V AVDD33 + 0.3 V
IRQ, CSB, SCLK, SDO,
SDIO, RESET
DVSS −0.3 V DVDD33 + 0.3 V
Junction Temperature 150°C
Storage Temperature −65°C +150°C
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
sections of this specification is not implied. Exposure to
absolute maximum ratings for extended periods may effect
device reliability.
THERMAL RESISTANCE
θ
JA
is specified for the worst-case conditions, that is, a device
soldered in a circuit board for surface-mount packages.
Table 5. Thermal Resistance
Package Type θ
JA
1
Unit
160-Lead Ball, CSP_BGA
31.2 °C/W
1
θ
JA
measurement in still air.
ESD CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily accumulate on
the human body and test equipment and can discharge without detection. Although this product features
proprietary ESD protection circuitry, permanent damage may occur on devices subjected to high energy
electrostatic discharges. Therefore, proper ESD precautions are recommended to avoid performance
degradation or loss of functionality.
Note that this device in its current form does not meet Analog Devices’ standard requirements for ESD as measured against the charged
device model (CDM). As such, special care should be used when handling this product, especially in a manufacturing environment. Analog
Devices will provide a more ESD-hardy product in the near future at which time this warning will be removed from this data sheet.