Datasheet

AD9637 Data Sheet
Rev. A | Page 22 of 40
Jitter Considerations
High speed, high resolution ADCs are sensitive to the quality of the
clock input. The degradation in SNR at a given input frequency
(f
A
) due only to aperture jitter (t
J
) can be calculated by
SNR Degradation = 20 log
10








×
×
J
A
tfπ
2
1
In this equation, the rms aperture jitter represents the root mean
square of all jitter sources, including the clock input, analog input
signal, and ADC aperture jitter specifications. IF undersampling
applications are particularly sensitive to jitter (see Figure 55).
The clock input should be treated as an analog signal in cases
where aperture jitter may affect the dynamic range of the AD9637.
Power supplies for clock drivers should be separated from the
ADC output driver supplies to avoid modulating the clock signal
with digital noise. Low jitter, crystal-controlled oscillators make
the best clock sources. If the clock is generated from another
type of source (by gating, dividing, or other methods), it should
be retimed by the original clock at the last step.
Refer to the AN-501 Application Note and the AN-756
Application Note for more in-depth information about jitter
performance as it relates to ADCs.
1 10 100
1000
16 B
ITS
14 B
ITS
12
BIT
S
30
40
50
60
70
80
90
100
1
10
120
130
0.125ps
0.25ps
0.5ps
1.0ps
2.0ps
ANALOG INPUT FREQUEN
CY (
MHz)
10 BITS
8 BITS
RMS CLOCK JITTER REQUIREMENT
SNR (dB)
10215-054
Figure 55. Ideal SNR vs. Input Frequency and Jitter
POWER DISSIPATION AND POWER-DOWN MODE
As shown in Figure 56, the power dissipated by the AD9637 is
proportional to its sample rate. The digital power dissipation
does not vary significantly because it is determined primarily by
the DRVDD supply and bias current of the LVDS output drivers.
10215-055
400
300
350
250
200
150
10
ANALOG POWER (mW)
SAMPLE RATE (MSPS)
20 30 40
50 60 70 80
65MSPS
80MSPS
50MSPS
40MSPS
20MSPS
Figure 56. Analog Core Power vs. f
SAMPLE
for f
IN
= 9.7 MHz
The AD9637 is placed in power-down mode either by the SPI
port or by asserting the PDWN pin high. In this state, the ADC
typically dissipates 1 m W. D u r i ng p o we r -down, the output drivers
are placed in a high impedance state. Asserting the PDWN pin
low returns the AD9637 to its normal operating mode. Note
that PDWN is referenced to the digital output driver supply
(DRVDD) and should not exceed that supply voltage.
Low power dissipation in power-down mode is achieved by
shutting down the reference, reference buffer, biasing networks,
and clock. Internal capacitors are discharged when entering
power-down mode and then must be recharged when returning
to normal operation. As a result, wake-up time is related to the
time spent in power-down mode, and shorter power-down
cycles result in proportionally shorter wake-up times. When
using the SPI port interface, the user can place the ADC in
power-down mode or standby mode. Standby mode allows the
user to keep the internal reference circuitry powered when
faster wake-up times are required. See the Memory Map section
for more details on using these features.