Datasheet

AD9548 Data Sheet
Rev. E | Page 108 of 112
THERMAL PERFORMANCE
Table 156. Thermal Parameters for the AD9548 88-Lead LFCSP Package
Symbol Thermal Characteristic Using a JEDEC51-7 Plus JEDEC51-5 2S2P Test Board
1
Value
2
Unit
θ
JA
Junction-to-ambient thermal resistance, 0.0 m/s airflow per JEDEC JESD51-2 (still air) 18 °C/W
θ
JMA
Junction-to-ambient thermal resistance, 1.0 m/s airflow per JEDEC JESD51-6 (moving air) 16 °C/W
θ
JMA
Junction-to-ambient thermal resistance, 2.5 m/s airflow per JEDEC JESD51-6 (moving air) 14 °C/W
θ
JB
Junction-to-board thermal resistance, 1.0 m/sec airflow per JEDEC JESD51-8 (moving air) 9 °C/W
θ
JC
Junction-to-case thermal resistance (die-to-heat sink) per MIL-Std 883, Method 1012.1 1.0 °C/W
Ψ
JT
Junction-to-top-of-package characterization parameter, 0 m/sec airflow per JEDEC JESD51-2 (still air) 0.1 °C/W
1
The exposed pad on the bottom of the package must be soldered to ground to achieve the specified thermal performance.
2
Results are from simulations. The PCB is a JEDEC multilayer type. Thermal performance for actual applications requires careful inspection of the conditions in the
application to determine if they are similar to those assumed in these calculations.
The AD9548 is specified for a case temperature (T
CASE
). To
ensure that T
CASE
is not exceeded, an airflow source can be used.
Use the following equation to determine the junction tempera-
ture on the application PCB:
T
J
= T
CASE
+ (Ψ
JT
× PD)
where:
T
J
is the junction temperature (°C).
T
CASE
is the case temperature (°C) measured by the customer at
the top center of the package.
Ψ
JT
is the value as indicated in Table 156.
PD is the power dissipation (see the Power Dissipation section).
Values of θ
JA
are provided for package comparison and PCB
design considerations. θ
JA
can be used for a first order approx-
imation of T
J
by the equation
T
J
= T
A
+ (θ
JA
× PD)
where T
A
is the ambient temperature (°C).
Values of θ
JC
are provided for package comparison and PCB
design considerations when an external heat sink is required.
Values of θ
JB
are provided for package comparison and PCB
design considerations.