Datasheet

Evaluation Board User Guide UG-073
Rev. 0 | Page 9 of 12
Section VII Section IX
This section of the SPI configures common-mode options
and xDAC analog gains as follows:
This section of the SPI software configures the I and Q auxiliary
DACs as follows:
Enable/disable IR
CM
and QR
CM
Enable/disable I/Q auxiliary DAC
Set internal IR
CM
and QR
CM
values
Set I/Q auxiliary DAC code
Set internal IGAIN and QGAIN values
Section X
Section VIII
This section of the SPI configures the INL/DNL calibration of
the main DAC.
This section of the SPI configures the retimer of the DUT as
follows:
Automatic or manual retimer selection
Readback or setting of retimer phase
08698-007
SECTION I
SECTION III
SECTION IV
SECTION V
SECTION II SECTION VI
SECTION IX
SECTION X
SECTION VII
SECTION VIII
Figure 7. Default SPI Front Panel Settings