Datasheet

AD8368
Rev. B | Page 18 of 20
Component Function Default Conditions
JP4
Jumper for AGC Mode of Operation. Provides feedback from the detector output to the
gain pin.
JP4 = not populated
(VGA mode)
SW1
Mode Switch. Low mode puts the part in gain-down mode. High mode puts the part in
gain-up mode. AGC operation requires gain-down mode.
SW1 = JP2
SW2 Power-Down. The part is disabled when the enable pin is tied to ground. SW2 = JP3
05907-044
Figure 41. Component Side Silkscreen
05907-045
Figure 42. Circuit Side Silkscreen
05907-046
Figure 43. Component Side Layout
05907-047
Figure 44. Circuit Side Layout