Datasheet

AD8209 Data Sheet
Rev. B | Page 4 of 16
Parameter Test Conditions
1
Min Typ Max Unit
POWER SUPPLY
Operating Range 4.5 5.5 V
Quiescent Current Typical, T
A
1.6 mA
Quiescent Current vs. Temperature V
OUT
= 0.1 V dc, V
S
= 5 V, T
OPR
AD8209WBRM
2.7
mA
AD8209WHRM 3.0 mA
PSRR V
S
= 4.5 V to 5.5 V, T
OPR
66 80 dB
TEMPERATURE RANGE
For Specified Performance at T
OPR
AD8209WBRM −40 +125 °C
AD8209WHRM −40 +150 °C
1
V
CM
= input common-mode voltage.
2
Source imbalance < 2 Ω.
3
The AD8209 preamplifier exceeds 80 dB CMRR at 10 kHz. However, because the output is available only by way of the 100 kΩ resistor, even a small amount of pin-to-
pin capacitance between the IN pins and the A1 and A2 pins might couple an input common-mode signal larger than the greatly attenuated preamplifier output. The
effect of pin-to-pin coupling can be neglected in all applications by using a filter capacitor from Pin 3 to GND.
4
The output voltage range of the AD8209 varies depending on the load resistance and temperature. For additional information on this specification, refer to Figure 12
and Figure 13.
5
The output voltage range of A2 assumes that Pin 3 (A1 output) and Pin 4 (A2 input) are shorted together. A 25 kΩ load resistor is used for testing.
6
The output voltage range of A2 assumes Pin 4 (A2 input) is driven with an external voltage source. A 25 kΩ load resistor is used for testing.