Datasheet

AD8197B
Rev. 0 | Page 4 of 28
Parameter Conditions/Comments Min Typ Max Unit
SERIAL CONTROL INTERFACE
5
Input High Voltage, V
IH
2 V
Input Low Voltage, V
IL
0.8 V
Output High Voltage, V
OH
2.4 V
Output Low Voltage, V
OL
0.4 V
PARALLEL CONTROL INTERFACE
Input High Voltage, V
IH
2 V
Input Low Voltage, V
IL
0.8 V
1
Differential interpair skew is measured between the TMDS pairs of a single link.
2
AD8197B output meets the transmitter eye diagram as defined in the DVI Standard Revision 1.0 and the HDMI Standard Revision 1.3.
3
Cable output meets the receiver eye diagram mask as defined in the DVI Standard Revision 1.0 and the HDMI Standard Revision 1.3.
4
Typical value assumes only the selected HDMI/DVI link is active with nominal signal swings and that the unselected HDMI/DVI links are deactivated. Minimum and
maximum limits are measured at the respective extremes of input termination resistance and input voltage swing.
5
The AD8197B is an I
2
C slave and its serial control interface is based on the 3.3 V I
2
C bus specification.