Datasheet

AD8192
Rev. 0 | Page 4 of 28
Parameter Symbol Conditions/Comments Min Typ Max Unit
Rise Time
10% to 90%, C
LOAD
= 1500 pF, R
PULLUP
= 27 kΩ; or C
LOAD
=
7200 pF, R
PULLUP
= 3 kΩ
50 100 μs
Fall Time
90% to 10%, C
LOAD
= 1500 pF, R
PULLUP
= 27 kΩ; or C
LOAD
=
7200 pF, R
PULLUP
= 3 kΩ
5 10 μs
Leakage
Off-leakage test conditions from HDMI Compliance Test
Specification Test ID: 8-14
1.8 μA
HOT PLUG DETECT
Output Low Voltage V
OL
R
PULLUP
= 800 Ω to +5 V 0.4 V
1
VREF refers to the voltage at the VREF_AB or VREF_COM pins. VREF should be at the same supply voltage as that to which the external pull-up resistors are connected.
Table 3. Power Supply and Control Logic Specifications
Parameter Conditions/Comments Min Typ Max Unit
POWER SUPPLY
AVCC Operating range (3.3 V ± 5%) 3.135 3.3 3.465 V
AMUXVCC Operating range (5 V ± 10%) 4.5 5 5.5 V
VREF_AB 3 5 5.5 V
VREF_COM 3 5 5.5 V
QUIESCENT CURRENT
AVCC Outputs disabled 40 45 mA
AVCC Outputs enabled, no pre-emphasis 60 70 mA
AVCC Outputs enabled, maximum pre-emphasis 100 120 mA
VTTI Input termination on
1
40 54 mA
VTTO Outputs enabled, output termination on 40 50 mA
Output termination on, maximum pre-emphasis 80 100 mA
DVCC 10 15 mA
VREF_AB 1 10 μA
VREF_COM 1 10 μA
AMUXVCC 10 20 mA
POWER DISSIPATION
Outputs disabled 215 318 mW
Outputs enabled, no pre-emphasis 545 765 mW
Outputs enabled, maximum pre-emphasis 881 1200 mW
I
2
C® AND LOGIC INPUTS
2
Input High Voltage, V
IH
Serial interface 2.4 V
Input Low Voltage, V
IL
Serial interface 0.8 V
I
2
C AND LOGIC OUTPUTS
Output Low Voltage, V
OL
Serial interface, I
OL
= +3 mA 0.4 V
1
Assumes that the unselected HDMI/DVI link is deactivated through the hot plug detect line, as required by the DVI Standard Revision 1.0 and HDMI Standard Revision 1.3a.
2
The AD8192 is an I
2
C slave and its control interface is based on the 3.3 V I
2
C bus specification.